Hawks Grip 1270A, 1270B, 1270C Non-Sanding Primer Chemical Bonding Product • Vinyl/Moisture Cured Urethane • Non-Sanding Primer • Adhesion Promoter Before Application of Tuff Stuff epoxy aafor Blister Protection Product Description Benefits Vs Competition Hawks Grip is intended for application directly to the fiberglass hull in place of sanding, and used in combination with Tuff Stuff for superior blister protection. Product Information Colors: Finish/Sheen: Mix Ratio: Solids by Volume : Shipping Weight: Flash Point: VOC: Blue High Gloss • • • • • • Design to go under Tuff Stuff Better Adhesion Fast drying Harder Primer Less Number of Coats 100% Reduction Means Less Product Needed CT INRMATIO Application Details Part A: Part B: Part C 25% 7lbs./gal. 24 F 635 gram/liter Film Thickness: 1-2 mils wet equals 0.25- 0.5 mils dry Recommended Coats: 1 Theoretical Coverage: 450 Sq.Ft./per .75GL Kit @ recommended film thickness Method: Induction/ Sweat-in Time: Thinner: Cleaner: Pot Life: Brush, roller and spray 0 Minutes N/A MEK, Acetone 8 HRS Application Intervals Substrate Temp. Min. 73°F (23°C) 20mins Drying Time (Hrs) Max. Overcoat 4 HRS NA Consult your Sea Hawk Representative for the system best suited for surfaces to be protected. NEW NAUTICAL COATINGS, INC. 14805 49th Street North • Clearwater, FL 33762 • (727) 523-8053 • 1-800-528-0997 • FAX (727) 523-7325 www.seahawkpaints.com

Hawks Grip 1270A, 1270B, 1270C Non-Sanding Primer Limitations Application Apply in good weather when air and surface temperatures are above 50°F (10°C). Surface temperature must be a least 50°F (10°C) above dew point. For optimum application properties, bring material to 70-80°F (21-27°C) temperature range prior to mixing and application. Unmixed material (in closed containers) should be maintained in protected storage between 40° and 100°F (4-38°C). Apply by brush, roller or spray. Apply 1-2 mil wet. Equipment Brush: China Bristle Roller: Solvent resistant Roller 3/8” pile smooth to medium prewash...