RESOLCOAT VI 5090 Vinylester Gelcoat Compatible Epoxy DESCRIPTION The VI5090 is a high resistance Gelcoat formulated on a Vinylester resin base. Its main characteristics are a very high resistance to solvents and chemical agents, which makes it an excellent product for tooling, but also its high TG of 105 degrees makes it a product of choice for Pre-preg parts For tooling, the VI 5090 enables the mould to have a permanent high gloss aspect resisting to many cycles between waxing/polishing. Thanks to its low dilatation module when exposed to temperature and its flexibility, the VI5090 is not prone to cracks and the appearance of mat zones. The VI 5090 comes in a Neutral (transparent) Color but can be delivered in any RAL color or with RAL pigments APPLICATION Application with spray gun or brush are both possible. In order to spray the VI 5090, it is possible to dilute it with styrene up to 5% and Acetone up to 3%. To avoid any risks of porosity, we recommend to catalyze the VI5090 with Resoltech MEKP (2 to 2,5%). As always when using a product in a new application, it is always recommended to test the system on a small surface of the same characteristics of the main surface to be sprayed or painted with rollers or brushes. PHYSICAL CHARACTERISTICS IN LIQUID STATE AT 23° C Properties Spray Gun Brush & Roller Units Norms application application Viscosity mPa.s * Brookfield RVF sp. 4/4 rpm 9000 - 15000 14000 - 20000 (cP) CQP/C/001 mPa.s * Cone & Plate 220 - 300 750 - 900 (cP) CQP/C/013 Density 1,1 - 1,2 1,1 - 1,2 g/cm3 CQP/C/003 Flash Point 34 34 °C ASTM D 3278 - 95 Gel time : 1,5 % (MEKP) 10 - 25 10 - 25 minutes CQP/C/014 2 % (MEKP) 25 - 45 25 - 45 minutes CQP/C/014 Shelf life of the product is 3 month after production date 3 3 month PHYSICAL & MECHANICAL CHARACTERISTICS ONCE POLIMERIZED Properties Tensile Strength Flexural Modulus Elongation at Break HDT Barcol Hardness Values 60 3500 2.0 105 35 Unit MPa MPa % °C 934-1 Norms ISO 527 - 1/2 - 1993 ISO 527 - 1/2 - 1993 ISO 527 - 1/2 - 1993 ISO 75 - 1/2 - 1993 ASTM D 2583 - 87 Health & Safety : It is advised to follow basic rules such as avoiding skin contact, wear masks when producing dust. Please read our standard health and safety sheet for more information. In case of eye contamination, wash with water and seek medical advice. The data provided in this document is the result of tests and is believed to be accurate. We do not accept any responsibility over the mishandling of these products and our liability is limited strictly to the value of the products we manufacture and supply. RESOLTECH - 35, impasse Emeri - Pôle d'activités - 13510 EGUILLES - FRANCE S.A.R.L au capital de 20 000 € Tél : 04 42 95 01 95 - Fax : 04 42 95 01 98 - e-mail : [email protected] - Site web : www.resoltech.com