Catalogs >
RESOLTECH >
1800 ECO

1800 ECO
1 / 5Pages

Catalog excerpts

resoltech * resoltech 1800 ECO Hardener 1804 ECO Biobased infusion epoxy system - 33% biobased on the mix - Very low viscosity and high wetting properties - Tg up to 94°C - Cures at room temperature - 2h of pot life on a 500g mix

Open the catalog to page 1

RESOLTECH 1800 ECO/l804 ECO is an advanced infusion and injection epoxy resin system, it is 34% biobased on the mix. It is suitable to manufacture structural composite parts with any kind of reinforcements : flax, hemp, glass, carbon, aramid... The constant low viscosity and the excellent wetting properties make the 1800 ECO/ 1804 ECO a premium choice for RTM applications : infusion, injection... Thanks to its outstanding adhesion properties, the resulting composites will show excellent fatigue resistances. This system has excellent cross linking properties and enables to release parts from...

Open the catalog to page 2

1804 ECO : Limpid colorless liquid Mix : Opalescent neutral liquid Visual aspect ! 1800 ECO : Opalescent neutral liquid Reactivity measurements realized on Trombotech®

Open the catalog to page 3

To avoid residual stress in the composite and possible shrinkage. The 1800 ECO/1804 ECO epoxy system should not be used at a temperature above 50°C. In order to obtain the maximum thermo-mechanical properties, it is necessary to respect the recommended curing cycle. The table below shows the glass transition temperatures (DMA) according to different curing cycles. Measurements on pure resin according to the following standard : ISO 178 Water absorption : ISO 62

Open the catalog to page 4

HEALTH & SAFETY 1800 ECO/1804 ECO : - Plastic jerrycan kit of 1kg + 0.26kg - Plastic jerrycan kit of 5kg + 1.3kg - Plastic drum kit of 30kg + 7.8kg - Drum kit of 200kg + 2 x 26kg TRANSPORT & STORAGE Keep containers sealed and away from heat and cold preferably between 10°C and 30°C in a well ventilated area. Our products are guaranteed in their original packaging (check expiry date on the label). Skin contact must be avoided by wearing protective nitrile gloves & overalls or other protective clothing. Eye protection should be worn to avoid risk of resin, hardener, solvent or dust entering...

Open the catalog to page 5