SERRATURE DA INFILARE PER PORTE MORTISE DOORLOCKS FREE GO Design: Giangi Razeto Fitting instructions Operation instructions WARNING! Handels to be mounted with BATTERY OFF or SLIDER OFF () 1 Power SLIDER Switch on/switch off (ON OFF ) Spindle-hub contact First fit the spindle with the electric contact downward in order to enable electric contact with the hub (click). When Fitting handles, make sure that the spindle’s spring edges are in contact with handles’spindle housing. Do not drill the spindle wen tightening the grub screw. Only now connect the battery and swich ON the slider () if LEDs flash there is an anomaly. Swich OFF the slider, check the contacts and retry. 2 Ten colours control button 3 Luminous intensity control button (dim, normal, bright light) 4 Extractable battery box 5 Lock electric contact 6 Striker/lock electric contact Battery Recharge battery (closed door and power slider (1) downward-ON) for al least 8 hs when fitting LEO set. Power slider (1) OFF (upward) when general power is switchedoff for a long period. These rules will guarantee longer battery life! Lock/striker (5/6) electric contact The striker to be mounted so that: - the striker electric contact (6) fit togeter the lock electric contact (5) - the gap between frame and door (striker plate/lock face plate) is to be between 1-5 mm. Energy consumption With the slider ON and closed door the battery charges till the soil of 4 V then it stops to load. At this point the battery uses the charge till the soil of 3,6 V then restarts to load. If the battery charge goes down 3,3 V the lights switch OFF waiting to be loaded (close the door) and saving the residual battery charge. The handle RGB LED can stay ON: 4 hours with WHITE color (3 LEDs ON), open door and bright light; 8 hours with single color (RED, GREEN or BLUE), open door and bright light: 18 hours with single color (RED, GREEN, BLUE), open door and dim light. Se non diversamente specificato, si intende ottone cromato Items are intended brass chrome plated unless otherwise specified