RipEX-HS – Master Station ź 1+1 hot redundancy ź Two standard RipEX units inside ź Hot swappable ź Independent power supplies ź AC/DC power supply options ź Automatic changeover ź Switch-over time < 2 s ź Auto toggle mode ź 19´ rack 3U ź 1× ETH, 1× SFP, 1× COM ź 4x HW alarm output ź –40 to +70 °C RipEX-HS is a hot-standby master station, 1+1 redundant, fully monitored, hot swappable equipment. It is assembled with two standard RipEX units, each powered by its own independent power supply. A controller takes care of automatic changeover in case of failure. Changeover conditions are widely configurable. Since both units are booted and use identical MAC addresses, exceptional switch-over time of less than 2s is achieved. Fully redundant option (RipEX2-RD) without any controller and switching is available for RipEX2. Redundant connection of connected technology and redundant antennas are mandatory whereas they are optional for RipEX2-HS. LED panels, HW alarm outputs, SNMP traps and standard RipEX units inside makes RipEX-HS configuration and control quite easy and maintenance can be done by anyone familiar with RipEX. RipEX-HS The same as RipEX2-HS except: ź 3× ETH, 2× COM ź Internal fan ź One way mounting ź Always with controller ź Only without int. duplexer © RACOM, Mírová 1283, 592 31 Nové M

Operating modes There are two standard RipEX units with identical configurations inside RipEX-HS. Both units are booted, however only one is active. The interfaces – Ethernet, COM, (SFP), Antenna of the second unit are disconnected. ● Auto – primary active is RipEX “A”, when it fails, controller When the active unit status changes to “down” (when a controlled value exceeds the respective threshold), the controller automatically switches all interfaces to the second unit and it takes over all functions. Since both units are using the same MAC addresses (MAC cloning), there is a minimal drop-out...