Lightspeed
2Pages

LIGHTSPEED Technical Data Sheet Product Line Lightspeed prevents marine growth adhering to the surface of underwater lights. This provides a boat owner with; • Asset protection and damage prevention, • Reduced time and effort during cleaning, • Increased lifetime of the light, • Improved performance of the light. Typical Uses As a fouling preventative coating for underwater lights. Physical Properties Binder type Solvent Colour Finish Dry time - Silicone polymer - Aromatic/Aliphatic Blend - Clear coating - Glossy - 3 hours touch dry 8 hours hard dry at 20°C Theoretical coverage - 11 m2 / L | 448 sq ft/US gallon Recommended wet film build - 90 microns per coat Shelf life - 24 months Surface Preparation & Application See application video at www.propspeed.com/application WARNING: Always wear safety glasses and protective gloves when installing. Step 1: Set Up and Initial Clean - Gloves must be worn at all times. - Tape off any areas that you do not wish to coat. - Clean the surface to be coated with the Lightclean wipe provided. Immediately remove any residue with a clean, dry drag. Ensure the surface is 100% clean and dry before proceeding. Step 2: Application - Squeeze the Lightspeed Clear Coat onto the provided application brush. Tape off any areas that you do not wish to coat - Gently apply one thin coat of Lightspeed. - Make sure there are no heavy runs or sags in the Lightspeed Clear Coat. You’ll have anywhere between 5 to 10 minutes to touch these up. Step 3: Dry Time Product name: Lightspeed Date of revision: 2022-03-28 Copyright © 2022 Propspeed International Ltd. All rights reserved

Lightspeed requires a minimum of 8 hours to dry before launching. In cold conditions, 5-13°C (40 – 60°F), we recommend at least 24 hours drying before launching. Lightspeed is not adversely affected by sitting out of the water for extended periods of time in warm or cold climates. Zero toxic substances Good fouling prevention properties Clear coating Long service life Easily recoated Soft coating, care required to prevent mechanical damage Must be removed completely when recoating Contains silicone and careful use is required to prevent contamination of other surfaces The Propspeed system...