BTAL-01 INSTALLATION and USER Guide Before installing the BTAL-01 module, connect the wiring temporarily, making sure the system works properly. To help minimize interference, do not install the BTAL-01 Module close to any metallic objects (i.e. power supply, battery or amplifier). POWER CONNECTIONS GND(-): Connect the ground wire/black/ - to the negative (-) battery terminal or other good power ground POWER(+): Connect the power wire/red/+12V to the ”amplifier ON” wire on the back of the stereo. (This wire is usually blue). If the stereo is not equipped with this wire, connect the power wire/red/+12V to a switched +12V source such as accessory or an ignition switch. RCA: Connect the White and Red RCA from BTAL-01 module to the Red and White RCA labeled AUX IN or Line IN on the back of the stereo. Make sure the stereo is turned on and the BTAL-01 is also powered on. Change the Source/Mode button to AUX In or Line In on your stereo. Open the Bluetooth setting on your device (refer to your device’s User Manual for Bluetooth setting). Choose “Poly-Planar BTAL-01” from the list of available Bluetooth links. PIN or password is not required. Some devices may take more than 30 seconds to initiate after pairing or may not pair at all. turn off the stereo and the device and pair it again. Note: The BTAL-01 module can only be paired one at a time. To pair with a different device, you must remove pairing from the current device. Once paired, you can now start playing your favorite music from your music device. All music selection & playback is controlled from your device. Operating Range is up to 33 feet (will vary, dependent on installation). INCOMING PHONE CALLS On most phone devices, while streaming music and you receive a phone call, the music will be paused and the ring tone will be played through your speakers. Use your phone to answer the call. When the call is completed, the music will automatically s

TECHNICAL SPECIFICATIONS Cable Length: Bluetooth: Operating Range: Dimensions (LxWxH): Operating Voltage: Operating Current: WARRANTY INFORMATION This unit is warranted to be free of defects in material and workmanship for a period of one year. Warranty is subject to proper installation and operation within the published specifications. Except as provided below, Poly-Planar will repair or replace, at its discretion, any unit returned prepaid to our facility with proper documentation and determined to be defective in normal use. Poly-Planar is not liable for any consequential damages. LIMITS OF...