SURFACE PREPARATION
1Pages

{{requestButtons}}

Catalog excerpts

SURFACE PREPARATION - 1

finish quality is totally smooth. Plastimo surface conditions. ferro cement different paints. Improves adhesion on a surface with a previous coat or on an antifouling in poor condition. above waterline. High performance surfaces + protection from abuse Preparation and priming for paintwork below the waterline By calculating precisely the surface area to be painted (primer and antifouling), you will determine the quantity necessary to obtain best results and efficiency. The performance of the antifouling results to a large extent from the quantity and the thickness applied (even more so if you have chosen a fast polishinq antifoulinq). In all cases, the total quantity calculated must be applied. • Calculation of the surface to be painted, in m2 (Beam + Draw) x Load waterline = Surface area in m2 Beam + Draw) x Load waterline x 0.75 = Surface area in m2 Beam + Draw) x Load waterline x 0.50 = Surface area in i • Calculation of paint quantity - = Number ot litres per coat. Multiply this result by the number of coats recommended. Use the largest brush possible. Use a woollen roller with a short pile and a paint brush for hard to reach areas. Apply paint in regular inverted layers crosswise onto a surface of 1 m2

Open the catalog to page 1

All Plastimo catalogs and brochures

  1. catalogue

    676 Pages

  2. liferaft

    1 Pages

  3. Plastimo 2014

    620 Pages

  4. blooks

    1 Pages

Archived catalogs