Fresh Water Speed Coating • Super Slick Finish • Ultra-Thin Film Thickness Prevents • Contains Moly-Disulfide & PTFE for Reduced Friction • No Sanding Required Between Coats • Excellent for Fiberglass, Wood, & Steel Note: Color occur between chips shown. Color changes upon immersion Finish: Metallic Flat Slickening Agents: Copper Flake Polytetrafluoroethylene (PTFE) Molybdenum Disulfide Application Method: Short nap roller or airless Maximum Roller Thickness: 3/16" Number of Coats: Three initial; one or two in subsequent years Wet Film Thickness: 3 mils Dry Film Thickness: .25 mils Thinner: Isopropyl Alcohol To Touch To Recoat To Launch *The above dry times are minimums. SC-21 may be recoated and launched after the minimum time shown. SC-21 fresh water speed coating is an ultra-thin, super slick, low friction paint film for boat bottoms. It is the ideal racing finish for fresh water boats. SC-21 combines copper powder, Moly-Disulfide, and PTFE to produce a super-slick paint film that reduces surface friction allowing the hull to slide through the water. SC-21 is recommended for use on fiberglass, wood and properly primed steel boats. It is easy to apply and dries in 15 minutes. Color changes upon immersion.

Application Systems and Tips Mix paint thoroughly to ensure slickening agents are evenly dispersed throughout the can. All surfaces must be clean, dry and properly prepared prior to painting. Do not apply SC-21 on aluminum. When rolling use only a high-quality short nap (maximum 3/16” nap) roller cover. Apply using thin coats; over-application of this product will virtually assure inadequate coating performance. Previously Painted Surfaces: If the previous coating is in good Information condition, thoroughly sand with 80 grit paper followed by thorough sanding with 180-grit then 220-grit and...