Pontoon Pro Antifouling for Aluminum Hulls TECHNICAL BULLETIN 1008 6/13  Multi-season antifouling paint designed for pontoon boats and aluminum hulls Uses copper-free Econea biocide - will not cause galvanic corrosion Second organic biocide added for slime protection Self-polishing ablative paint film eliminates paint build up and the need for sanding Compatible over all bottom paints Pontoon Pro was designed specifically for pontoon boats and aluminum hulls. It combines the breakthrough, metal-free Econea™ biocide with a powerful slime fighting agent for dual-biocide, multi-season protection. This copper-free formula can be safely applied to all aluminum hulled boats. It provides excellent antifouling protection, with an ablative surface that polishes with use. The paint film wears away over time like a bar of soap, eliminating build up or the need for sanding between coats. It can be used over all previously painted surfaces in good condition. Pontoon Pro can be hauled and re-launched without any loss of effectiveness. One or two coats per season are recommended for optimal performance. PHYSICAL DATA FINISH: Eggshell 1008 Black COMPONENTS: 1 CURING MECHANISM: Solvent release SOLIDS (theoretical): By weight - 80 +/- 3% By volume - 59 +/- 3% COVERAGE: 500 sq. ft/gal. (includes 20% loss factor) VOC: 320 g/l (as supplied) Econea...6.0% Zinc Omadine...4.80% FLASH POINT: 105°F APPLICATION DATA METHOD: Brush, Roller, Airless or Conventional Spray. ACTIVE INGREDIENTS: Note: Color differences may occur between actual and color chips shown NUMBER OF COATS: 2 or 3 DRY FILM THICKNESS PER COAT: 1.5 mils (2.6 wet mils) APPLICATION TEMP: 40° F. Min. / 90°F. Max. DRY TIME* (HOURS): To Recoat To Launch 90°F 2 2 70°F 3 4 50°F 6 8 *The above dry times are minimums. Pontoon Pro may be recoated after the minimum time shown. There is no maximum dry time before launching. THINNER: 120 Brushing Thinner 121 Spraying Thinner ASSOCIATED PRODUCTS 92 Bio-Blue Hull Surface Prep D-95 De-waxer 120 Brushing Thinner 121 Spraying Thinner 4100/4101 Pettit-Protect White High-Build Epoxy Primer 4700/4701 Pettit-Protect Gray High-Build Epoxy Primer 6455/044 Metal Primer 6627 Tie-Coat Primer 6456 Underwater Metal Kit 4400/4401 Aluma Protect Epoxy Primer Splash-Zone A-788 Epoxy

Pontoon Pro Antifouling for Aluminum Hulls APPLICATION INFORMATION It is necessary to thoroughly mix the paint before using. If possible shake the can of paint on a mechanical paint shaker. Before using check the sides and bottom of the can to make sure all the pigment has been mixed in. If mixing is going to be done with a wooden paddle or an electric drill mixer, pour off half of the liquid from the top of the can into another can and then properly mix in any settle pigment; then remix the two parts together thoroughly. Adhere to all application instructions, precautions, conditions, and limitations...