Technical Information • Durable, smooth, thin-film finish resists build up Finish: Flat • Provides cost-effective seasonal antifouling protection • Easy to apply and safer to use • Compatible over all bottom paints Biocide: Cuprous Oxide...25.25% Flash Point: > 200°F • Simple soap and water clean up Application Method: Brush, roller, airless or conventional spray Maximum Roller Thickness: 3/16” Number of Coats: 1 minimum per season with additional coat at waterline Wet Film Thickness: 3.75 mils Dry Film Thickness: 1.5 mils 1343 Green (Quart and Gallon) Application Temp: 50° F. Min. / 90°F. Max. Thinner: Water 1643 Red (Quart and Gallon) 1843 Black (Quart, Gallon, and 2-Gallon) Note: Color differences may occur between actual and color chips shown Dry Time*: (hours) To Touch To Recoat To Launch 90°F ¼ 1-1/2 6 70°F ½ 3 10 50°F 1 6 16 * Above times are minimums - there is no maximum dry time before launching. available to create a hybrid paint film strong enough to handle the tough marine environment without building up over time. Its crossbreed finish is extremely durable like a hard paint, yet it self-polishes over time like a seasonal ablative. Soap and water cleanup along with no strong solvent smell, yields a user-friendly application. Neptune5 does not require sanding between coats saving time and money. With low VOC it's ideal for marinas under restrictions. Neptune5 can be used over all previously painted surfaces.

Application Systems and Tips Neptune5 is easily applied by brush, roller or spray. When rolling use only a high-quality short nap (maximum 3/16” nap) roller cover. Apply using thin coats; over-application of this product will virtually assure inadequate coating performance. For the smoothest possible finish: Thin the paint approximately 5-10% with clean fresh water. Wet the surface to be painted thoroughly with clean fresh water as well. This will provide a truer color and Application smoother finish. Information Slight variations in color and surface texture are not uncommon and should not be...