1. Catalogs
  2. Northern Lights
  3. M843NW3 - 12/10 kW Northern Lights marine generator
video corpo

M843NW3 - 12/10 kW Northern Lights marine generator
1 /1Page

M843NW3 - 12/10 kW Northern Lights marine generator

M843NW3 - 12/10 kW Northern Lights marine generator
1 /1Page

Catalog excerpts

M843NW3 - 12/10 kW Northern Lights marine generator-1

M843NW3 Specifications and Dimensions Dimensional Drawing COOLANT OVERFLOW BOTTLE FILL COOLANT FILL FUEL FILTER Three Phase with 0.8 PF Voltage regulation Lugger L843N Engine Type Vertical inline 3 cylinder diesel Approximate fuel use 1800 RPM @ full load2 Installation Data & Weight Wet exhaust elbow Raw water inlet CRANKCASE OIL FILTER CRANKCASE OIL DIPSTICK INTAKE AIR 39.4 (1000) SNORKEL (KEEP CLEAR NO CONNECTION) M843NW3 Overall Dimensions: L x W x H: 39.4 x 22.8 x 25.2 inch (1000 x 580 x 641 mm) Sound Enclosure Dimensions L x W x H: 39.4 x 22.8 x 25.7 inch (1000 x 580 x 654 mm) Sound Enclosure Weight: 75 lbs. (34 kg) Fuel inlet and return Approximate dry weight Dimensions given in inches (mm). Dimensions subject to change without notice. Contact dealer or visit www.northern-lights.com for most current installation drawings. 1. Based on SAE J1995 and ISO 3046. 2. Actual fuel consumption will vary depending on operating conditions Engine Block • Four cycle, 3 cylinder, liquid cooled, naturally aspirated, overhead valve diesel. • Swirl combustion chambers improve fuel efciency and reduce smoke. • Glow plugs for quick cold starting. Cooling System • Freshwater cooling system in heat exchanger or keel cooled configuration. • One-piece heat exchanger, expansion tank and liquid cooled exhaust manifold. Fewer troublesome hoses and gaskets. Cast iron to resist corrosion and electrolysis. • Heat exchanger cooling is standard. Cupro-nickel tube-type heat exchanger has removable ends for easy cleaning. Rubber impeller seawater pump of bronze and stainless steel is gear driven; no belt. Fuel System • Fuel system is self-venting. • Injection pump with 5% mechanical governor for close AC frequency control. • Pintle injectors with replaceable tips. • Mechanical lift pump with hand primer. No electric pump to fail. • Large spin-on fuel lter. • Flexible fuel lines routed to fuel manifold. • Stop solenoid controls the fuel rack, not the throttle, to eliminate speed variances and linkage problems. • Meets US EPA Tier III emission standards at date of manufacture. • Washable air cleaner in cast intake manifold reduces intake noise. • Cast iron, wet exhaust elbow for safety. Lubrication System • Full ow, spin-on oil lter with bypass. • 4.2 qt (4 ltr) oil capacity for better lubrication. 200 hour oil change intervals. • Oil drain for quick, clean oil changes. • Closed crankcase vent system traps oil vapor and keeps engine room clean. M843NW3 Features and Benefits DC Electrical System • DC system uses reliable relays instead of an unrepairable printed circuit board. • 12 volt starter motor and battery charging alternator with regulator and belt guard. • Standard panel: Remote mount S-1B has hour meter, stop-start switch with run light and preheat switch. • Expandable to six panels up to 110 feet from the set. • 20 foot (6m) plug-in panel harness lets you mount your panel anywhere onboard. Better than inaccessible unit mount panels that are prone to vibration problems. • Low oil pressure, high coolant temp and high exhaust temp safety shutdowns standard. • Northern Lights, direct coupled, brushless AC generator is maintence free. 4 lead, 1 phase, 50 or 60 Hz output standard. 12 lead, 3 phase optional. Conservative heat rise rating: 95oF/50oC ambient. • Automatic voltage regulator (AVR) is powered by dedicated AC winding for true 300% short circuit capability and circuit breaker protection. Quick ±1% RMS no load to full load voltage regulation. • Generator features high quality, Class “H” epoxy insulation, accessible diodes, over-sized bearings and junction box for wiring. Special Equipment • Welded steel base frame with drip pan. • Four plateform mounts isolate vibration. • White, long-life polyurethane paint. • Operator’s and parts manuals standard. Classification Standards • Consult factory for details. www.northern-lights.com Northern Lights, Inc. • 4420 14th Ave. NW., • Seattle WA 98107 Tel: 206-789-3880 • 1-800-762-0165 • Fax: 206-782-5455 Information and dimensions subject to change without notice. Northern Lights and Lugger are registered trademarks of Northern Lights, Inc. © 2012 All rights reserved. Litho USA. S104 5/12

 Open the catalog to page 1

All Northern Lights catalogs and brochures

  1. DECS Brochure

    2  Pages

  2. L768

    1  Page

Archived catalogs

  1. DECS Brochure

    2  Pages

  2. M844DW3

    1  Page

  3. M944T3

    1  Page

  4. NL673L4

    1  Page

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.