WEATHERFAST PREMIUM TIMBER OIL JULY 2014 PRODUCT DATA SHEET NORGLASS LABORATORIES PTY.LTD. A.B.N. 92 001 807 245 P.O. Box 312, Neutral Bay. NSW 2089 Australia 59 Moxon Road, Punchbowl NSW Ph: 61 2 9708 2200 Fax: 61 2 9796 3069 Email: [email protected] www.norglass.com.au WEATHERFAST PREMIUM TIMBER OIL DESCRIPTION: A modified, low odour resin coating for timber where a natural grain appearance is desired. Contains U/V inhibitors for added protection. Fast drying and nongreasy film. Primary use is for open grained timbers/decks where a temporary “natural” wet look is desired without the cumulative effect of build-up coats being produced which would involve eventual stripping. Light amber 9-12sq. metres per litre per coat (subject to timber porosity) DRYING TIME: Touch dry: 1 hour at 20 degrees C and 50% relative humidity Multiple coats can be used providing that they are all applied in a wet on wet fashion. Once drying commences further coats will only be deposited on top of the previous layer and thus produce a “varnish like” film. Where this happens, eventual stripping will be required to reinstate the original condition. MIXING RATIO: VOLUME SOLIDS: FLASH POINT:

WEATHERFAST PREMIUM TIMBER OIL U.N. NUMBER: TEAK: Sand down/caustic scrub the surface until all traces of oxidised material are removed. When the natural honey coloured timber is produced a liberal wash down with Acetone or Methylated Spirits on clean rags is recommended to (a) remove the sanding dust and (b) to produce a dry, oil-free, porous state of timber that will increase the penetration of the Norglass Premium Timber Oil. OTHER TIMBERS: Treat the same as above. On more dense wood the penetration of Norglass Premium Timber Oil will obviously be restricted therefore the less number of coats...