shipshape primer undercoat

Product catalog summary

Description: Shipshape Primer-Undercoat is a densely pigmented, two-component epoxy coating known for its excellent filling and adhesive properties. It forms a paint film with high abrasion, chemical, and solvent resistance.

Uses: This product serves as a primer and undercoat for materials such as timber, fiberglass, aluminum, and concrete. It is also used as an undercoat over Norglass NORSHIELD ANTI-CORROSIVE PRIMER on steel surfaces and areas where Northane colors are applied.

Properties (at 20°C):

Color: White
Toxicity: Refer to precautions
Finish: Low to semi-gloss
Coverage: Up to 12 sq. meters per mixed liter, depending on porosity and texture
Drying Time: Touch dry in 2 hours
Recoating: Spraying – wet on wet; Brush/roller – overnight
Pot Life: 8 hours
Mixing Ratio: 3 parts base to 1 part hardener by volume
Thinning: Spraying – 25% - 33⅓% Northane Spraying Thinners; Brush/roller – 5% Norglass Epoxy Thinners
Weight/Liter: 1.51 kg when mixed
Volume Solids: 50%
Flash Point: 27°C (Solvent)
Clean Up: Norglass Epoxy Thinners or Northane Spraying Thinners
UN Number: 1263

Preparation: Ensure the surface is clean, dry, sanded, and well-prepared.

Application: Mix 3 parts of Shipshape Base with 1 part Shipshape Hardener by volume, stir thoroughly, and let stand for 10 minutes before use. Apply using a brush, roller, airless, or conventional spray. Adjust spraying thinners according to the pressure system used or thin 25-33% at 50-70 psi.

Transportation: Classified as Dangerous Goods Class 3.2 HAZCHEM 3[Y]PGIII. Available in pack sizes of 4 liters, 2 liters, 1 liter, and 500 ml.

Precautions: The product is polyamide cured, requiring careful handling. The hardener is alkaline and can cause skin irritation. Ensure adequate ventilation when spraying, avoid smoking, and keep away from open flames.

First Aid: If skin sensitivity occurs, move to fresh air and wash thoroughly. In case of poisoning, contact a doctor or Poisons Information Centre. If swallowed, do not induce vomiting; provide milk or water.

Special Instructions: Avoid using below 10°C as curing will be affected. Reseal the hardener container immediately after partial use to prevent deterioration. If not used within 48 hours, transfer remaining contents to a smaller container to minimize air exposure and seal tightly.

Disclaimer: Any advice or information provided by NORGLASS is given in good faith and believed to be reliable, but without liability or responsibility.

Catalog excerpts

May 2010 PRODUCT DATA SHEET SHIPSHAPE PRIMER-UNDERCOAT DESCRIPTION: A densely pigmented, 2 pack epoxy coating with excellent filling and adhesive properties. Produces a paint film with very good abrasion, chemical and solvent resistance. USES: As a primer and undercoat for timber, fibreglass, aluminum and concrete, as well as an undercoat over Norglass NORSHIELD ANTI-CORROSIVE PRIMER on steel surfaces, and all areas where Northane colours are to be applied. PROPERTIES (at 20°C) ° COLOUR: White TOXICITY: See Precautions FINISH: Low to semi-gloss COVERAGE: to 12sq.metres/mixed litre (subject to porosity and texture) DRYING TIME: Touch dry in 2 hours RECOATING: Spraying – wet on wet. Brush/roller – overnight POT LIFE: 8 hours MIXING RATIO: 3 parts base to 1 part hardener by volume THINNING: Spraying – 25% - 33⅓% Northane Spraying Thinners Brush/roller – 5% Norglass Epoxy Thinners WEIGHT/LITRE: 1.51kg when mixed VOLUME SOLIDS: 50% FLASH POINT: 27°C (SOLVENT) CLEAN UP: Norglass Epoxy Thinners or Northane Spraying Thinners UN NUMBER: 1263

Open the catalog to page 1

Page 2 – Shipshape Primer-Undercoat PREPARATION: Ensure the surface is clean, dry, sanded and well prepared. APPLICATION: Mix 3 parts of Shipshape Base with 1 part Shipshape Hardener by volume, stir thoroughly and allow to stand for a further 10 minutes before using. Apply by brush roller, airless or conventional spray. Adjust Spraying Thinners according to the pressure system used or thin 25-33% at 50-70 psi. TRANSPORTATION: Dangerous Goods Class 3.2 HAZCHEM 3[Y]PGIII Pack sizes available – 4litre, 2 litre,1litre, 500ml PRECAUTIONS: This product is Polyamide cured and all precautions must be...

Open the catalog to page 2

All Norglass catalogs and brochures

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list