Sep 2009 PRODUCT DATA SHEET NORGLASS LABORATORIES PTY.LTD. A.B.N. 92 001 807 245 P.O. Box 312, Neutral Bay NSW 2089 Australia 59 Moxon Road, Punchbowl NSW Ph: 61 2 9708 2200 Fax: 61 2 9796 3069 Email: [email protected] www.norglass.com.au NoRUST ANTI-CORROSIVE PRIMER DESCRIPTION: A state-of-the-art ANTI-CORROSIVE all surface primer. It contains superior non toxic rust inhibiting pigments and is formulated to resist humidity and salt spray conditions. Because of NoRUST’s outstanding adhesion it can also be used as a primer for non-ferrous metals andother surfaces. USES: Ferrous metals - Stainless Steel - Cast Iron - Aluminium - Weathered Galvanised Iron - Bronze - Fibreglass - and many other substrates. PROPERTIES (at 20°C) COLOUR: Red Oxide White & Grey TOXICITY: Non Toxic pigments FINISH: Low sheen Texture COVERAGE: 10m2 per litre (D.F.B. 40 microns) DRYING TIME: Touch dry 20 minutes RECOATING: 2 - 3 HOURS - (24 hours if a 2 pack is to be brush applied. Allow longer if volatile 2 pack spraying thinners are to be used. POT LIFE: N/A MIXING RATIO: N/A THINNING: Maximum of 5% Weatherfast Brushing Thinners if brushed or rolled. For spraying reduce 25-33 1/3% with only WEATHERFAST SPRAYING THINNERS Do not substitute other Solvents WEIGHT/LITRE: 1.320kg VOLUME SOLIDS: 36% FLASH POINT: 27°C CLEAN UP: WEATHERFAST BRUSHING THINNERS or WEATHERFAST SPRAYING THINNERS UN NUMBER: 1263

Page 2 – NoRust PREPARATION: Steel: Sandblast to white metal (AS 1627.4) or power sand to a clean metal state. Other Metals: Sandblast or solvent degrease and sand to a clean metal state. APPLICATION: Brush & Roller: Stir thoroughly and apply straight from the can immediately after the surface has been prepared. In hot weather up to 5% of Weatherfast Brushing Thinners can be added to assist flow. At 20°C a second coat may be applied after 3 hours. On metal this coat should be applied at right angles to the first coat. In colder conditions allow longer drying time between coats. Spray: Thin to...