NORFLEX EPOXY FILLER JULY 2014 PRODUCT DATA SHEET NORGLASS LABORATORIES PTY.LTD. A.B.N. 92 001 807 245 P.O. Box 312, Neutral Bay. NSW 2089 Australia 59 Moxon Road, Punchbowl NSW Ph: 61 2 9708 2200 Fax: 61 2 9796 3069 Email: [email protected] www.norglass.com.au NORFLEX EPOXY FILLER DESCRIPTION: A two part Epoxy/Polyamine/Polyamide filler. Characterized by high strength, non shrinking, low sag, resistance to chemicals and excellent adhesion to timber, metals, concrete, fiberglass and other materials. For filling gaps, holes and imperfections in most surfaces. Ideal for use as a fairing filler on large areas because of its ability to flex with the substrate. Offer a 30% weight saving by mass over NORFILL. Cream (when mixed). Colour can be altered using Norglass Pigment Paste. Low gloss to flat, depending on application. DRYING TIME: Hard cure 12 hours. Full cure 7 days. May be painted over after 12 hours MIXING RATIO: 2:1 (Base to hardener) by volume VOLUME SOLIDS: FLASH POINT: NORGLASS EPOXY THINNER (insoluble once cured before settling occurs).

NORFLEX EPOXY FILLER A perfectly clean and dry surface is essential for maximum adhesion. Where used on metal surfaces the substrate must be adequately primed and sealed before cosmetic fairing takes place. Place 2 equal parts of NORFLEX base onto a flat mixing board and position an equal 1 part of NORFLEX hardener alongside. When assessed that all 3 piles are of equal value, blend together thoroughly until well mixed then apply with a rubber squeegee or filling knife. Allow overnight to cure before sanding. When final fairing is achieved the NORFLEX will need to be overcoated with SHIPSHAPE...