*mynauticexpo

Norcells

Product catalog summary

Description: Norcells is a blended lightweight extender designed for use with Norglass epoxies, primarily for filling and fairing surfaces.

Properties (at 20°C):

Colour: Dry white fluffy powder
Toxicity: Non-hazardous according to Worksafe Australia
Drying Time: 3-4 hours
Recoating: Overnight
Pot Life: Depends on resin volume
Mixing Ratio: Discretionary
Weight/Litre: 100g
Clean Up: Use Norglass Epoxy Thinner

Preparation: Mix the epoxy resin with hardener, pour Norcells on top, replace the lid, shake for 20 seconds, and stir with a drill stirrer. Transfer to a flat palette to minimize heat.

Application: Apply using a squeegee, trowel, or spatula. Ensure consistency is stiff enough to prevent sagging on vertical surfaces.

Transportation: Non-hazardous.

Precautions: Avoid inhaling dust. Use protective clothing, mask, and goggles.

First Aid:

If swallowed: Rinse mouth and drink water.
If in eyes: Rinse with water for 15 minutes.
If on skin: Wash with soap and water.
If inhaled: Move to fresh air.

Special Instructions: Advice provided by Norglass is given in good faith but without liability.

Catalog excerpts

PRODUCT DATA SHEET NORGLASS LABORATORIES PTY.LTD. A.B.N. 92 001 807 245 P.O. Box 312, Neutral Bay. NSW 2089 Australia 59 Moxon Road, Punchbowl NSW Ph: 61 2 9708 2200 Fax: 61 2 9796 3069 Email: [email protected] www.norglass.com.au NORCELLS DESCRIPTION: A blended lightweight extender for Norglass epoxies. For filling and fairing surfaces. Dry white fluffy Powder Nor Hazardous according to the criteria of Worksafe Australia Varies according to Epoxy Resin mix. DRYING TIME: Subject to resin volume. MIXING RATIO: VOLUME SOLIDS: FLASH POINT: NORGLASS EPOXY THINNER

Open the catalog to page 1

NORCELLS PREPARATION: After the epoxy resin is mixed with the hardener, and decanted into a larger container a quantity of Norcells is poured on top of the resin and then immediately replace the lid tightly. Then shake vigorously for 20 seconds to wet the Norcells. Open the lid, and stir again with a portable drill stirrer attachment to complete the dispersion process. This thickened mass should be transferred to a large flat palette of timer/metal etc. to minimize heat development. Apply to the surface with a squeegee, trowel or spatula. On vertical surfaces, the consistency should be made stiff...

Open the catalog to page 2

Norcells

Norcells

Catalog excerpts

All Norglass catalogs and brochures