PRODUCT DATA SHEET NORGLASS LABORATORIES PTY.LTD. A.B.N. 92 001 807 245 P.O. Box 312, Neutral Bay. NSW 2089 Australia 59 Moxon Road, Punchbowl NSW Ph: 61 2 9708 2200 Fax: 61 2 9796 3069 Email: [email protected] www.norglass.com.au A microfined white powder. As an extender with epoxy and polyester resins. Flat white Varies with resin consistency DRYING TIME: MIXING RATIO: Normally same volume as mixed resin but can vary widely VOLUME SOLIDS: FLASH POINT: Norglass Epoxy Thinner

After the resin and hardener have been mixed and blended the Microtalc can then be added using a flat stirrer or spatula until the desired consistency is achieved, then spread the mass onto a large board or palette to reduce the heat generation. Apply by trowel, squeegee or flat bladed knife. No special arrangements required. Wear gloves, goggles and mask when incorporating. Procedure normally not required Flush with plenty of water for 15 minutes. If irritation persists see a doctor. Was with soap and water Remove to fresh air. If difficulty in breathing give oxygen and seek medical attention...