METAL-ETCH CLEANER JULY 2014 PRODUCT DATA SHEET NORGLASS LABORATORIES PTY.LTD. A.B.N. 92 001 807 245 P.O. Box 312, Neutral Bay. NSW 2089 Australia 59 Moxon Road, Punchbowl NSW Ph: 61 2 9708 2200 Fax: 61 2 9796 3069 Email: [email protected] www.norglass.com.au METAL-ETCH CLEANER DESCRIPTION: Metal-Etch Gel is a phosphoric acid metal conditioner specifically designed for pre treatment of bare aluminium, galvanised Iron and non ferrous alloys such as brass, copper and bronze. Metal-Etch Gel will clean and condition the metal surface to promote good adhesion of paint. Metal-Etch Gel has been formulated as a viscose liquid/gel to provide better hold on vertical surfaces. Shaking or stirring the container for 1-2 minutes will liquify the METAL-ETCH for a more fluid application. By allowing the container to stand for 1-2 hours, the product will revert to a gel. For etching all non ferrous metals prior to painting or clear lacquering. Pale yellow/green, odourless gel (liquifies if stirred or shaken) Contains corrosive acid. Refer to Safety Directions and First aid Instructions on the label Spread Rate of up to 14m² per litre MIXING RATIO: Metal-Etch Cleaner is designed to be used as is. Thinning is not possible FLASH POINT: N/A – Metal-Etch Cleaner is non-flammable and non-combustible.

METAL-ETCH CLEANER Remove any oxidation (powdery film) by scrubbing with a nylon scouring pad soaked in NORGLASS ACETONE. On new shiny metal galvanic iron plating or rolling oils (aluminium) are to be treated by washing over the area with NORGLASS ACETONE using clean rags. Apply NORGLASS METAL-ETCH CLEANER to the bare metal surface direct from the container using a clean brush or alternatively pour a quantity onto the bare metal surface and spread it with a soft nylon broom or sponge. Metal-Etch will spread at a rate of up to 14m² per litre. Allow contact with the metal for 20 minutes MAXIMUM...