ShuttlePilot Fixed The ShuttlePilot Fixed (SPF) is installed on the permanently-sited vessel (usually FPSO or similar). Combined with a ShuttlePilot Portable (SPP), a ShuttlePilot Remote (SPR) and ShuttlePilot Display (SPD) to complete a full ShuttlePilot system for Offshore Oil & Gas operations like moorings, approaches and transfers. The ShuttlePilot Fixed: • Calculates accurate position, heading and ROT for the vessel on which it is fitted • Where needed, transmits this data to the SPR on the other vessel • Receives similar data from the other vessel • Optionally, sends both sets of data, to on-board LAN network • Optionally receives remote Emergency Shutdown signal from ShuttlePilot Remote Case Weight Power Requirements ShuttlePilot Fixed (SPF) UHF antenna AC/DC Power Supply 425mm wide x 128mm High Rack Mounted Case (19 inch x 3U) 8kg 110V or 230 VAC (Customer to specify) 45 Hz to 65 Hz 1.5Amp UPS option (available on request) SPECIFICATIONS Receiver Type GPS L1. GLONASS L1 GPS L2. GLONASS L2. BEIDOU Channels Update Rate SBAS Tracking Position Accuracy 744 channels 1Hz 3 Channel. Parallel L Band single frequency 0.25m (SBAS/DGPS) 0.08m (Atlas) UHF Radio Frequency Range Occupied Bandwidth Modulation Type Range Sensitivity Output Power External interfaces Serial Ports LAN (Option) ESD Contacts (Option) GPS Antennas UHF Antenna Mains Power Full duplex RS232 (x2), Full duplex RS485 (x2) RJ45 NO/NC volt-free (contact rating 0.5A, 12V) TNC (F) x2 N-type (F) 3-pin IEC Environmental Operating Temperature Storage Temperature Humidity Shock and Vibration EMC 0.01m (RTK) Heading Accuracy ± 0.01 ° ROT Accuracy ± 0.5°/min Cold Start < 60s Warm start < 20s Satellite Reacquisition <1s Aiding devices: Gyro & Tilt sensors Antenna Input Impedance 50Q ir^ Innovate | Integrate | Communicate