Catalogs >
Nautix >
WATERTIGHT

WATERTIGHT
2Pages

Catalog excerpts

Fast cure Epoxy Filler - Finishing The printing process may render some of the colour samples imperfectly. We recommend testing the paint before committing to a colour. PRODUCT DESCRIPTION Nautix WATERTIGHT is high-quality epoxy filler composed of micronized compounds (very resistant to moisture). This product is especially recommended for small repairs on Gelcoat/metals above and below the waterline. This filler (density 1) must be applied before application of finishing coats (You can fill up to 5mm in one application, without the risk of sagging / slumping). This product has very easy mixing ratio (1 : 1 by volume and weight), makes it easier for measurement of components, and allows optimization of working time. Very hard, very smooth and easy sanding, Nautix WATERTIGHT is recommended for application on deck, hull and keel. This Filler is 100% solvent free (Benzyl alcohol and phenol free). PRODUCT INFORMATION Finish Mixing ratio (volume) Mixing ratio (weight) Flash point Unit size Typical shelf life Density Colour Drying / Overcoating Information ^Recommended time slot. Go to Application for more information h=hours min=minutes TYPE OF SURFACES • GRP / Composite • Steel • Aluminium • Rigid wood SURFACE PREPARATION Check the substrate : Before overcoating, remove all loosely adhering and flaking paint, feather back all edges. You can grit with brush in different areas to test adhesion of current antifouling. The surface should be degreased with Nautix SD and free of all contaminants (oil, grease, salt etc). Sand (or sandblast) the surface with P120 grade paper to improve adhesion of primer. Rinse with fresh water and let dry. Technical recommendation Apply epoxy filler between 2 coats of primer. The best option is between coat #1 and #2. Then if you need to sand, you will be able to see distinctly the difference between films of filler and primer. • Apply the first layer adapted primer. SAFETY INFORMATION • Work in well-ventilated area (ensure adequate ventilation during use), wear suitable protective clothing, gloves, glasses and eye/face protection. Unprotected person must be kept away from treatment area. Dispose of protective gloves and equipment after use. • Read the label safety section for Health and Safety Information before application. Nautix - Parc d'activites Les 5 chemins - 24 rue Nicolas Appert - 56520 Guidel, France Tel: +33.(0)2.97.65.32.69 Fax: +33.(0)2.97.65.03.54 info@nautix.com — www.nautix.com Before Printing, think about environment! 05/10/2016

Open the catalog to page 1

WATERTIGHT Fast cure Epoxy Filler - Finishing Application methods : Trowel or batten. Apply between 10 and 30°C. Do not apply when there is a chance of condensation forming on the substrate (Dew-Point) : substrate, ambient air and product temperatures must be close. Avoid applying in adverse weather conditions : strong wind, strong sunlight, high/low temperatures, high humidity or rain. Use appropriate filler after the first coat of primer has been applied. Do not use ventilator or heater directed on the surface. Mix the two components thoroughly to get an homogeneous light pink colour just...

Open the catalog to page 2