Catalogs >
Nautix >
U3

U3
2Pages

Catalog excerpts

1-pack white undercoat with high-opacity for 1-pack finishes The printing process may render some of the colour samples imperfectly. We recommend testing the paint before committing to a colour. PRODUCT DESCRIPTION Nautix U3 is 1-pack white undercoat enamel giving smooth and plain base for 1-pack finishing paints. Its excellent opacity allows for easy colour changing. Nautix U3 is especially recommended as base before application of STARLAC 1-pack enamel or DECK GRIP 1-pack nonskid paint. The white colour of U3 allows to increase the gloss of finishing paints. PRODUCT INFORMATION Finish Coverage Flash point Unit size Typical shelf life Thinner/Cleaner Colours Matt 14m2/L per layer (roller/brush) 23°C <FP<55°C 0.75L - 2.5L 5 years Nautix WS white Drying / Overcoating Information d=days h=hours min=minutes *Minimum overcoating time recommended for 1 layer (100pm wet thickness) - Please refer to Application TYPE OF SURFACES • GRP / Composites • Steel (for more details, please refer to our technical specifications for “Steel boat") • Wood (for more details, please refer to our technical specifications for “Wood boat") SURFACE PREPARATION New surface • The surface should be degreased with Nautix SD and free of all contaminants (oil, grease, salt etc). • Sand with P120 grade paper to improve adhesion of undercoat. • Rinse with fresh water and let dry. • Ensure the substrate to be dried, degreased, and free of dust. Over previously painted surfaces • Check the condition of substrate : the former paint must not come unstuck from the support or must not crumble. Scrape with a brush to check support quality and remove any loosing paint. • Substrate in good condition : Technical recommendation Substrate must be cleaned and dried. Please refer to Nautix technical data sheets if you need any further information. It's recommended to work in dust-dree environment. This product is not suitable for permanently immersed surfaces - Wash with a suitable detergent, rinse with fresh water (high-pressure water blasting or with brush) and allow to dry. - Degrease the surface with Nautix SD. And then abrade with P240 grade paper. - Rinse with fresh water and let dry. • Substrate in poor condition : - Remove all previous coatings. - Surface must be degreased with Nautix SD and dust free. - Rough sand with 120 grit to favour adherence. - Rinse with fresh water and let dry. SAFETY INFORMATION • Work in well-ventilated area (ensure adequate ventilation during use), wear suitable protective clothing, gloves, glasses and eye/face protection. Unprotected person must be kept away from treatment area. Dispose of protective gloves and equipment after use. • Read the label safety section for Health and Safety Information before application. Nautix - Parc d'activites Les 5 chemins - 24 rue Nicolas Appert - 56520 Guidel, France Tel: +33.(0)2.97.65.32.69 Fax: +33.(0)2.97.65.03.54 info@nautix.com — www.nautix.com Before Printing, think about environment! 06/10/2016

Open the catalog to page 1

U3 1-pack white undercoat with high-opacity for 1-pack finishes Application methods : brush, roller, spray gun , airless. Apply between 10 and 30°C (ideally inside with hygrometry rate no greater than 85%). Do not apply when there is a chance of condensation forming on the substrate (Dew-Point) : substrate, ambient air and product temperatures must be close. Homogenize the product with a blender. It’s recommended to sand with P400 grade paper between coats. Respect carefully overcoating time. If filling is required, use appropriate filler after the first coat of undercoat has been applied....

Open the catalog to page 2