Catalogs >
Nautix >
BLUE FILLER

BLUE FILLER
2Pages

Catalog excerpts

BLUE FILLER Light Epoxy Filler for large area application The printing process may render some of the colour samples imperfectly. We recommend testing the paint before committing to a colour. Nautix BLUE epoxy filler is new generation low-density product (density 0.65), and can be considered as one of the lightest yacht epoxy fillers available in the marketplace. This filler is especially recommended for large surfaces fairing (hull or profile). You can fill up to 20mm in one application, without the risk of sagging / slumping. Produced with high quality water-resistant compounds, Nautix BLUE Filler can be applied over and below the waterline, and on GRP/composite, rigid wood, and metal. Nautix BLUE Filler offers friendly preparation (simple 1/1 mixing ratio in volume and weight) and smooth application. Once cured, this product is very easy to sand. Nautix BLUE Epoxy Filler is 100% solvent free (Benzyl alcohol and phenol free). ^Recommended time slot : Go to Application for more information h=hours min=minutes Finish Mixing ratio (volume) Mixing ratio (weight) Flash point Unit size Typical shelf life Density Colour TYPE OF SURFACES • GRP / Composite • Steel • Aluminium • Rigid wood Technical recommendation Apply epoxy filler between 2 coats of primer. The best option is between coat #1 and #2. Then if you need to sand, you will be able to see distinctly the difference between films of filler and primer. Check the substrate : Before overcoating, remove all loosely adhering and flaking paint, feather back all edges. You can grit with brush in different areas to test adhesion of current antifouling. The surface should be degreased with Nautix SD and free of all contaminants (oil, grease, salt etc). Sand (or sandblast) the surface with P120 grade paper to improve adhesion of primer. Rinse with fresh water and let dry. • Apply the first layer adapted primer. • Work in well-ventilated area (ensure adequate ventilation during use), wear suitable protective clothing, gloves, glasses and eye/face protection. Unprotected person must be kept away from treatment area. Dispose of protective gloves and equipment after use. • Read the label safety section for Health and Safety Information before application. Nautix - Parc d'activites Les 5 chemins - 24 rue Nicolas Appert - 56520 Guidel, France Tel: +33.(0)2.97.65.32.69 Fax: +33.(0)2.97.65.03.54 info@nautix.com — www.nautix.com Before Printing, think about environment! 05/10/2016

Open the catalog to page 1

BLUE FILLER Light Epoxy Filler for large area application Application methods : Trowel or batten. Apply between 10 and 30°C. Do not apply when there is a chance of condensation forming on the substrate (Dew-Point) : substrate, ambient air and product temperatures must be close. Avoid applying in adverse weather conditions : strong wind, strong sunlight, high/low temperatures, high humidity or rain. Use appropriate filler after the first coat of primer has been applied. Do not use ventilator or heater directed on the surface. Mix the two components thoroughly to get an homogeneous light blue...

Open the catalog to page 2