Dimensions and technical data 2.900 WS 125 trolley washing machine 2.800 The wiring meets VDE requirements. Waste pipe to DN 70. Exhaust air from the machine including entrained air from the kitchen, 2.400 m3. Soft hot water to DN 25 0-3°dH The flow pressure must be minimum 2.5 and maximum 6 bar. The Installation requirements of DIN 1988 must be observed. Trough in floor covered by a grid (in the building) The appliances can be connected to the water supply without the need for intermediate security fittings. The appliances are installed ready for connection to the electricity supply and ready for operation. They are delivered for 3-phase 3 / N + PE 400 V, 50Hz current as standard. (Other forms of heating can be supplied on request). Machine decontamination of trolleys Pass-through machine Wash cycles per hour Useable volume Clean water per wash cycle Tank capacity Total connected load (motors) Roller door drive (option) Tank heating Boiler heating Dryer heating Information on KW heating output ± 5% MEIKO Maschinenbau GmbH & Co. KG Englerstr. 3 · 77652 Offenburg · Germany Tel. (+49)781/203-0 · Fax (+49)781/203-1121 www.meiko.de · E-Mail: [email protected] 340.030.00.07.06/GB/KD/2500 We reserve the right to make alterations in the course of further developme

mEIKO WS 125 trolley washer Powerful and efficient for hygienic trolley cleaning Hygiene and cleanliness is of paramount importance in hospitals, clinics and residential care homes, not to mention other applications, e.g. laboratories etc. Any trolley used to transport or remove goods and equipment (e.g. foodstuffs, bed-linen, waste products) must be cleaned to proper standards of hygiene. The MEIKO WS 125 trolley washer was especially developed to guarantee these demanding hygiene standards. It has an extremely efficient power-wash and rinse system for cleaning these trolleys economically and...

Functional details Made by and for professionals The dual wash and rinse systems which are adjusted to suit each trolley type are located on the left, right and over the trolley and move along the trolley at pre-set intervals, thus optimally cleaning the whole trolley surface several times during each washing process. Technology in the service of the user The generously-dimensioned wash-chamber provides sufficient space for all common types of trolleys. Trolleys can be efficiently and ergonomically loaded into and removed from the machine as its entrance is level with the surrounding floor. Wide...

Secure programming sequences for excellent hygiene Practice-oriented design provides the most benefit Outstanding results from the washing and rinsing processes are ensured by a PLC controlled thermochemical washing process with recirculating washwater. The dish-washing layout in a hospital kitchen providing meals for 1200 people and using dual chamber equipment (two WS 125 pass-through machines) The high efficiency of this washing-up kitchen is further increased by the incorporation of four waste funnels directly alongside the belt conveyor washing machine used for dishware and gastronorm containers....

The appliances are installed ready for connection to the electricity supply and ready for operation. They are delivered for 3-phase 3 / N + PE 400 V, 50Hz current as standard. (Other forms of heating can be supplied on request). The wiring meets VDE requirements. The appliances can be connected to the water supply without the need for intermediate security fittings. Soft hot water to DN 25 0-3°dH The flow pressure must be minimum 2.5 and maximum 6 bar. The Installation requirements of DIN 1988 must be observed. Waste pipe to DN 70. Exhaust air from the machine including entrained air from the kitchen,...