M-TU Turbine general datasheet

Product catalog summary

Product Information
Matre Turbine In-line Foam Proportioners are designed for reliability and efficiency. They activate with water flow and allow for testing or water-only operation by redirecting foam back to the tank, offering economic and environmental benefits. The robust construction ensures minimal maintenance.

General Product Features
The proportioners are available in materials such as Bronze, Stainless Steel, and Titanium. They support ANSI 16.5 150 lb RF and FF interfaces, with a design pressure of 20 bar and a test pressure of 30 bar. The water pressure range is 5-10 bar, and foam concentrate inlet pressure is a minimum of 0.75 bar abs. Insertion rates are 1% or 3%, compliant with NFPA 11 standards. Installation is flexible, with specific piping recommendations.

Flow Range and Interface Guide
Flow ranges are available with various interfaces. Selection tables for 1% and 3% insertion rates indicate availability across different sizes and flow capacities.

Dimensions and Interfaces
Standard dimensions and interfaces are detailed, with specific measurements provided for different flow rates and insertion percentages. For custom interfaces and materials, contact Matre.

Pressure Loss Data
Pressure loss data is provided for both 1% and 3% insertion rates, indicating the efficiency of the proportioners under different operational conditions.

Catalog excerpts

MATRE TURBINE IN-LINE FOAM PROPORTONER E-mail: [email protected]

Open the catalog to page 1

MATRE Turbine In-Line Foam Proportioners Matre Turbine In-line Foam Proportioners are known for their reliability. The foam proportioner starts to function as soon as water starts to flow through it. For testing purposes or to run the system with water only it is possible to open the bypass line and send the foam back to the tank. This represents a substantial economical and environmental saving and at the same time increasing safety. It also helps to simplify the fire fighting system as auxiliary valves can be omitted. The simple and robust construction of Matre Turbine In-Line Foam Proportioner...

Open the catalog to page 3

MATRE Turbine In-Line Foam Proportioners 4 Flow range and interface guide All the flow ranges are available with different interfaces. In the following tables you can find the available interface dimensions for the different flow ranges. 4.1 Selection of Matre turbine proportioners with 1% insertion 4.2 Selection of Matre turbine proportioners with 3% insertion Standard product dimensions and interfaces can be found in this section. All information in the following table apply to standard turbine proportioners. For information about different interfaces and materials contact us. For the related...

Open the catalog to page 4

MATRE Turbine In-Line Foam Proportioners For the required dimension go the section 5. The specifications and information herein are subject to change without notice.

Open the catalog to page 7

MATRE Turbine In-Line Foam Proportioners 7 Pressure loss data 7.1 In-line Turbine pressure loss at 1% insertion rate JÇI.iO 'SOUI.-'nnn Flow (l/iniii) The specifications and information herein are subject to change without notice.

Open the catalog to page 8

MATRE Turbine In-Line Foam Proportioners 7.2 In-line Turbine pressure loss at 3% insertion rate The specifications and information herein are subject to change without notice.

Open the catalog to page 9