GENERA TORS Control Panel The gen-set control panel was designed to include, in one single panel, the switches, control devices and the protection devices The components are the following : • Engine cut-off module for automatic stop of engine in case of high water temperature, low oil pressure, high alternator temperature. • Hour-meter. • Start-stop button. • Breaker for protection against of overload or short circuit. • Thermal switch for D.C. electric circuit. Engine • Easy access in case of maintenance to the feeding system and lubrication, of the sea/water pump and the air filter. • Safety stop in case of low oil pressure. • Safety stop in case high water/exhaust gas temperature. • Oil and fuel filters of easy access. Alternator • Synchronous, 4 poles, brush less self-excited, electronic voltage regulator (AVR). • Rotor and stator coated with epoxy resin against external agents. • Rotor dynamically balanced. • Insulation class H. Engine Model Type Cylinders (nr.) Cylinder block material Bore (mm) Stroke (mm) Displacement (cc) Power (hp) RPM Compression ratio Combustion system Engine head material Speed governor Lubrication system Oil sump capacity Engine stop system Fuel pump Fuel pump discharge (cm) Full load consumption (l/h) Starting battery (Ah-V) Battery charger (Ah-V) Starter (kW-V) Max. inclination Water pump flow (l/min) Type Cooling Voltage (V) Frequency (Hz) Max. power (kVA) Continuous power (kVA) Power factor (cos ø) Insulating class Voltage stability Frequency stability Soundproof cabin Cooling system A new project engineering design with a structure of a draw piece of aluminum supporting, painted aluminum panels type 5754 of high resistance to external agents. Good accessibility inside canopy, makes maintenance services more easy. The cooling of the engine is based on a closed inner flow of coolant. The system is based on a cupronickel heat exchanger seawater/coolant type, where the thermal exchange occurs between coolant and seawater. Two separate pumps contribute to the flow of the coolant and the sea water.

GENERA TORS Dimensions (Leng. x Width x Height) Weight Noise power level 50 Hz 2150 x 900 x 1200 mm (with canopy) 1106 Kg (with canopy) 61 dBA at 7mt FITTINGS EXHAUST COMPONENTS KIT SIPHON BREAK WATER-GAS SEPARATOR KIT STARTING REMOTE CONTROL PANEL WITH INSTRUMENTS This drawing is only a reference and is not indicated for the installation. For more information, you may contact your local dealer or mase generators S.p.A.. mase generators S.p.A. reserves the right to change the design or specifications without notice and without any obligations or liability whatsoever For more information, you...