IS 11.2 & IS 13.2
2Pages

mas ma s e GENERA TORS TNV rie se IS 11.2 11.2 kW 50 Hz IS 13.2 13.2 kW 60 Hz THE INTERCOOLER W/A Assures the perfect functioning of the generator independently of the external ambient temperature, therefore the alternator and the engine will work at ideal temperature optimizing the performance and reliability of the gen-set. Control Panel The gen-set control panel was designed to include, in one single panel, the switches, control devices and the protection devices The components are the following : • Engine cut-off module for automatic stop of engine in case of high water temperature, low oil pressure, high alternator temperature. • Hour-meter. • Start-stop button. • Breaker for protection against of overload or short circuit. • Thermal switch. Engine • Easy access in case of maintenance to the feeding system and lubrication, of the sea/water pump and the air filter. • Safety stop in case of low oil pressure. • Safety stop in case high water/exhaust gas temperature. • Double vibration dumping system. • Oil and fuel filters of easy access. • Oil drain pump. Alternator • Synchronous, 2 poles, self-regulated, brush less self-excited with electronic voltage regulator (AVR). • Rotor and stator epoxy resin coated against external agents. • Rotor dynamically balanced. • Insulation class H. Soundproof cabin A new project engineering design with a structure of a draw piece of aluminum supporting, painted aluminum panels type 5754 of high resistance to external agents. Of limited weight and easy accessibility to the inner cabin in case of maintenance services. Engine Model Type Cylinders (nr.) Cylinder block material Bore (mm. - in.) Stroke (mm.- in.) Displacement (cc. - CID) Power (hp) RPM Compression ratio Injection system Engine head material Speed governor Lubrication system Oil sump capacity with filter (l -gl) Engine stop system Fuel pump Fuel pump discharge (cm. - ft) 50 Hz 60Hz Yanmar 3TNV70 - HGE Diesel 4 stroke 3 Cast iron 70 - 2,7 76 - 3 854 - 52 18,1 21,8 3000 3600 23:1 Combustion camber Cast iron Centrifugal mechanical Forced 3,8 - 1 Stop solenoid Mechanical 70 - 2,3 Fuel consumption (l/h - gl/h) Air intake (l/min. - gl/min.) Starting battery (Ah-V) Battery charger (Ah-V) Starter (kW-V) Max. inclination Water pump flow (l/min. gl/min.) 4-1 4,9 - 1,4 1034 - 273 1240 - 327 70 - 12 40 - 12 1,2 - 12 30° Alternator 50 Hz 60Hz Synchronous, 2-poles, brush less self-excited Electronic Air/water ( Intercooler W/A ) 115 - 230 120 - 240 50 60 97,4 - 48,7 110 - 55 11,2 13,2 10,4 12,2 1 H ±2% ±5% Type Regulation Cooling Voltage (V) Frequency (Hz) Amps Max. power (kW) Continuous power (kW) Power factor ( cos ø ) Insulating class Voltage stability Frequency stability 25 - 6,6 Cooling system The cooling of the engine is based on a closed inner flow of coolant. The system is based on a heat exchanger seawater/coolant type, of cupronickel, where the thermal exchange occurs between the two liquids. Two separate pumps contribute to the flow of the coolant and the sea water. The cooling of the air inside the gen-set is obtained through a seawater/air heat exchanger. This provides the efficacious cooling of the alternator and the optimal temperature for the best performance and reliability of the gen-set despite its on board allocation and room temperature.

50 Hz IS 13.2 Dimension (Lenght x Width x Height.) Weight Noise Level 60 Hz GENERA TORS 50 Hz 60Hz 985 x 555 x 645mm - 38,8x21.85x25.4 (in.) (with soundproof box) 280 Kg. - 617 (lb)(with soundproof box) 50 dBA at 7mt (23 ft) FITTINGS EXHAUST COMPONENTS KIT SIPHON BREAK REMOTE CONTROL PANEL COMPLETED OF INSTRUMENTS Dealer: mas ma s e This drawing is only a reference and is not indicatly for the installation. For more information, you may contact your local dealer or mase generators S.p.A.. mase generators S.p.A. reserves the right to change the design or specifications without notice and...