Bantape Glass Cloth Cut Sheet
2Pages

DESCRIPTION Bantape®G11025 R/CW Glass Cloth backing (8x8 Mesh, 110 GSM Glass Cloth), combined with a high performance flame retardant cold weather solvent acrylic adhesive, protected by an easy-release silicone release paper. Glass Cloth backing provides excellent reflection heat. High quality adhesive with super strong adhesion and holding power offers reliable and durable Glass Cloth Facing joints and seams sealing in marine and industrial thermal insulation application, Good aging resistance both indoors and outdoors. Low moisture vapor transmission rate offers excellent sealing and patching performance. IMO Resolution MSC 61(67) Annex 1 Part 5 and Annex 2 IMO Resolution MSC 61(67) Annex 1 Part 2 and Annex 2 PRODUCT FORM & SIZE AVAILABLE Cut Roll: 75mm (3") / 100mm (4") Log Roll: 1200mm x 45 / 50m Jumbo Roll: 1200mm x 1000m / 1200m / 1350m IMPORTANT NOTE 1. The data above are typical values only, and should not be used for specifications purpose. 2. Tolerance: Weight and Thickness: 10%; Width: 3mm; Length: Cut Roll: 0.3m, Jumbo Roll 0.5%. TYPICAL APPLICATIONS HVAC industry for joining and sealing Foil-Scrim-Kraft Facing laminated fiberglass blanket / duct board joints and seams; joining and sealing flexible air duct seams and connections. General purpose holding, patching, sealing and masking applications – indoors and outdoors PRODUCT USE It is essential that the user evaluate the Bantape® G11025 R/CW Glass Cloth Tape product to determine whether it is fit for a particular purpose and user’s method of application. Good results will be obtained when applied to a clean, dry surface with a suitable pressure on Bantape® G11025 R/CW Glass Cloth Tape products between +10 ~ +40°C (+50 ~ +105 F). Surface Preparation It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied must be clean, dry, free of grease, oil or other contaminants. Storage & Self Life 18 months when stored at 21C (70F) / 50% relative humidity out of direct sunlight. The utilization of Bantape®G11025 R/CW Glass Cloth Tape must be checked with shipyard respectively class surveyor before installation. Bantape®G11025 R/CW Glass Cloth Tape should be additionally pressed on the Isover glass cloth faced minerwool products with a scraper. The right contact pressure of the Bantape®G11025 R/CW Glass Cloth Tape on faced light weight mineral wool products should be considered sufficiently. Postahane Mah. Sağlık Sok. No:26 34940 Tuzla-İSTANBUL/TÜRKİYE BANTAPE® is registered trade Marks of MARINSU İzolasyon San. Ve Tic. Ltd. Şti.

TYPICAL PHYSICAL PROPERTIES Postahane Mah. Saglik Sok. No:26 34940 Tuzla-iSTANBUL/TURKiYEl BANTAPE®lis registered trade Marks of MARINSU izolasyon San. Ve Tic. Ltd. Sti.l