Maretron’s Run Indicator Module monitors both AC and DC electrical circuits and reports, over an NMEA 2000® network, whether or not the electrical circuit is energized and running. The RIM100 works equally as well for monitoring manually switched loads (e.g., running lights, anchor lights, or deck lights) as it does for automatically switched loads. Monitoring automatically switched loads (e.g., bilge pumps, engine exhaust/intake fans, and transfer pumps) via the RIM100 is especially useful because you know exactly when equipment is, or isn’t running. PART NUMBER Run Indicator Module Water in Fuel Detector • Monitors and reports the running statuses of six independently connected devices • Works with both AC and DC loads • Works with both automatically and manually switched loads • Can indicate the status of a wide variety of loads - Bilge Pumps - Winches - Running Lights - Transfer Pumps - Exhaust/Intake Fans - Water in Fuel notification The following accessories are available for the RIM100: WIF-RK30880-E Water in Fuel Detector A WIF-RK30880-E Fuel detector mounted on the bottom of a fuel filter will provide a voltage when water is detected in the fuel. This voltage can be detected by the RIM100 and used to trigger an Alert or display an Indicator.

Spe cific i f i ca atio tion ns s Cert NMEA 2000® Parameter Group Numbers Maritime Navigation and Radio Communication Equipment & Systems Maritime Navigation and Radio Communication Equipment & Systems Electromagnetic Compatibility Default Rate Configuration Information Product Information Protocol PGNs PGN List (Transmit and Receive) 1 time/15 seconds and on switch change Response to Requested PGNs Binary Switch Bank Status Periodic Data PGNs NMEA Request/Command/Acknowledge Maretron Proprietary PGNs 128720 Parameter “ON” Voltage Range (DC) Parameter Power Consumption Load Equivalence Number...