Catalogs >
Maretron >
CLMD16

CLMD16
2Pages

Catalog excerpts

Product Features • NMEA 2000® Interface • IP67 Rated • Ignition Protected • Opto-Isolated from NMEA 2000®, eliminating potential ground loops • 16 Electronic Circuit Breakers (ECBs) for ON/OFF control over NMEA 2000® network For larger breakers and more circuits, the MPower® CLMD16 is a 16-Channel DC Load Controller Module. Four of the 16 breakers handle a maximum of 25 amps and twelve breakers handle a maximum of 12 amps with a total current capacity of 125 Amps. Additionally, circuits can be paralleled. The CLMD16 also supports two H-Bridge reversing polarity circuits that can be used for loads such as engine hatches, passerelles, trim tabs, etc. The CLMD16 has 8 inputs for hard-wired switches that can be used to switch breaker states, or as inputs for other data such as bilge alarms or hatch positions, etc. There are 3 inputs capable of monitoring tank levels. The CLMD16 handles many DC load types such as lights, pumps, motors, and electronics. An added benefit of the CLMD16 is that it reports the current through each of the 16 breakers. This allows you to determine if loads are drawing too much or too little electrical current. This information can be used to report overcurrent faults and under-current conditions such as burnt-out bulbs. Monitor and control onboard electrical and electronic systems and reset circuits onboard and remotely with the following devices: • Maretron MBB300C Black Box Maretron TSM810C Dedicated Touchscreen Garmin OneHelm™ Any device running Maretron’s awardwinning N2KView® V3 Software MPower devices can also be controlled by the new MPower 6-Rocker VMM Series Contura® Digital Switch Module and the new MPower 12-Button CKM Series Customizable Keypad. Each breaker is capable of carrying up to 12 or 25 Amps Individual breaker electrical current monitoring Breakers can have power-up states defined (ON, OFF, or previous states) Breakers can be locked against inadvertent actuation Capacitive touch switches for local control of all loads All inputs and outputs protected against short to Power and short to Ground Automatic ECB overcurrent shutdown Automatic ECB thermal shutdown (Overtemperature Protection) PART NUMBERDESCRIPTION CLMD16-R 16-Channel DC Load Controller Module w/A3708, A3709 & A3710 DTP06-4S J1 (Output) Mating Connector, Deutsch 0462-203-12141 J1 (Output) 14AWG Socket, Deutsch WP-4S J1 (Output) Wedge, Deutsch DT06-12SA J2 (Output) Mating Connector, Deutsch 0462-209-16141 J2 (Output) 14AWG Socket, Deutsch PART NUMBERDESCRIPTION W12S J2 (Output) Wedge, Deutsch 1028-043-1205 J2 Back Shell, 12 Way Plug, Deutsch DRC26-24SA J3 (I/O General Purpose) Mating Connector, Deutsch 0462-201-20141 J3 (I/O General Purpose) 16-20AWG Socket, Deutsch 0413-204-2005 Connector Seal Plug, 20 HD SER, Deutsch A3708 Output (J2) Mating Connector with 1m Flying Leads A3709 Output (J1) Mating Connector with 1m Flying Leads

Open the catalog to page 1