The Basics
1 / 6Pages

Industrial Series Analog Gauges The Industrial series was designed with the industrial equipment, workboats, pleasure boats and vehicles in mind. Industrial Series gauges are easy to install with the use of plug-in Deutsch connectors that significantly decrease rigging time. The plug-in connectors are waterproof and resist salt corrosion and dust intrusion. These gauges feature fade resistant powder coated pointers; SAE rims in a powder coat finish or in polished stainless steel. These finishes protect the rims and make them extremely resilient in harsh weather environments. Industrial Series Features • Standard gauge sizes • Plug-in connectors are waterproof and resist salt corrosion • Gauges are encased in non-ferrous hardware • Red LED lighting is standard • Available in 12 or 24 volt system • Powder coated pointers are fade resistant • SAE rims in flat black, white or stainless steel

Industrial Series Tachometers Gas tachometers are compatible with: 4, 6, & 8 cylinder, V-10 & Merc O/B 6 pulse/12 pole Base Part Number Tachometer Hardware Description Part Number DCH harness 24V 24” lead DCH harness 12V w/ tach filter, reduces needle bounce, 24” lead Tachometers- Diesel 4000 RPM Description Base Part Number mechanical signal generator driven

Industrial Series GPS Speedometers • Livorsi GPS Speedometers require a NMEA 0183 antenna/receiver. Included with GPS Speedometer • speedometer • memory recall • harness Base Part Number Included with GPS Speedometer Kit • speedometer • memory recall • harness • GPS antenna - antenna mounts with a 1/4” screw - antenna dimensions: 2 ¾" L x 2 3/8" W x 7/8" H

Industrial Series Mechanical Gauges hose kit vacuum boost Base Part Number Hose Kits - not to be used with fuel 10 feet of hose and fittings 25 feet of hose and fittings

Industrial Series Electric Gauges • These electric gauges require the use of a four pin connector wire harness (unless otherwise noted) that we call a DCH harness. • We offer these harnesses pre-assembled with labed wire leads, 24 inches in length. Base Part Number Fuel Level 0-90 OHMS DCH/DCH24, fuel level sender Fuel Level 240-33 OHMS DCH/DCH24, fuel level sender Trimmeter Merc & Yamaha 10-90 OHMS Water Level DCH/DCH24, water level sender DCH Harnesses- pre-assembled 12 volt system, 24 inch leads 24 volt system, 24 inch leads * Note: Available with Mega or Race Rim only.

Industrial Series Electric Gauges fuel level water level