Bennett Trim Tab Owners... why repair when you can UPGRADE? Lectrotab key advantages over Bennett Hydraulic Systems... No risk of hydraulic fluid leaks Lifetime warranty on actuators 100% reliable tab position indication No maintenance required Upper seal, located above any point on the ram which is exposed to fouling, cannot be damaged and is the primary ram sealing element. U.S. Patent No. 5,881,666. Controlled torque thrust bearing surface for good service life and positive braking against reverse freewheeling. Prevents unwanted tab retraction when under way. Vent-tube check valve allows air in but not out, thus providing automatic internal pressurization to about 8 PSI when the tab is retracted. U.S. Patent No. 5,881,666. Upper bracket can be positioned from vertical through horizontal and matches Bennett mounting hole pattern. CONTROL OPTION Rocker Switch Oval Control • Performs all standard trim tab control functions • Water resistant switches • Easily upgraded to Oval LED control switch • Combines a microprocessor based trim tab control with LED tab position indicators • Completely sealed watertight • Automatic tab retraction during ignition key switch or auxiliary switch off ? WHY LECTROTAB • Lifetime Warranty on Actuators • Patented Unique Design Features • World Class Customer Support • Wireless Control Options ON EASY INSTALLATI • Uses existing Bennett trim tabs • Uses same mounting holes as Bennett actuators • Uses existing Bennett wiring harness www.lectrotab.com • Toll Free 1

Bennett to Lectrotab Actuator Upgrade Installation & Wiring Instructions... Choose Standard Switch Panel (SAF-SC) AUX signal input (orange) must be connected to ignition switched +12V or 24V DC or Auxiliary panel switch source to enable power up and retraction of tabs Connect the Bennett wire harness to the switch panel using the supplied connectors Lectrotab actuator wires fit through existing oil line holes Lectrotab upper mounting brackets fit existing Bennett mounting holes Remove the Bennett wires from the hydraulic pump and connect using supplied terminals and block as shown Port Actuator...