Stainless Steel Trim Tabs HEAVY DUTY Lectrotab heavy duty stainless steel trim tabs incorporate a 90° taper bent edge to provide unmatched strength and reliability. All stainless steel tabs are fabricated with a continuous rolled and pinned hinge. This design eliminates the need for welding. The tabs are made of corrosion resistant 12 gauge, 304 stainless steel and are available in standard finish (as shown) or black powder coated stainless steel. Heavy duty tabs are available in 9“ (23cm) and 12“ (30cm) chord lengths (chord is the length from the transom to the tab trailing edge) and in widths between 9” (23cm) and 48” (122cm). See specification chart for dimensional details. All tabs exceeding a 24” (61cm) width feature a 90 degree bent up trailing edge for additional strength. For galvanic protection, pre-installed zinc anodes are also available. Lectrotab specializes in providing customized tab designs. Please contact Lectrotab for your specific tab needs. FEATURES • 90° Taper bent edges for additional strength • Strong, corrosion resistant 12 gauge, 304 stainless steel • Continuous rolled and pinned hinge provides added strength and eliminates the need for welding • Standard chord lengths available in 9” (23cm) and 12” (30cm) and widths from 9” (23cm) to 48” (122cm) • Custom chord lengths and widths are also available • Dual actuator mounting available (see dual actuator tab spec sheet) • Black powder coated finish available • Zinc anodes may be installed for additional galvanic corrosion resistance • Bent trailing edge standard for tabs exceeding 24”width • Includes carriage bolts and nuts for actuator mounting to tab Linear Devices Corporation 8790 Park Central Drive, Richmond, VA 23772 www.lectrotab.com, Ph 804-261-3888, Fax 804-264-3070 January 2011

STAINLESS STEEL TAB DIMENSTIONS Center Hole Pattern Repeated 1 Time HEAVY DUTY STAINLESS STEEL TAB MODEL IDENTIFICATION T T = Stainless Steel 12 gauge 1st Number (A) = Tab Chord Length (inches) 2nd Number (B) = Tab Width Across Transom (inches) 9008 9008 = 90° Taper Bent Side Edges 9017 = 90° Taper Bent Side Edges w/ Black Powder Coating SPECIFICATIONS Model Stainless Steel Linear Devices Corporation 8790 Park Central Drive, Richmond, VA 23772 www.lectrotab.com, Ph 804-261-3888, Fax 804-264-3070 January 2011