Rubber Refresher Plastic and rubber care for marine use Premium product for long-term care and preservation with a high-end finish for unpainted plastics, PVC and rubber. The silicone oil-free microemulsion with particularly easy application does not dissolve the surfaces and therefore does not create any sticky spots. Gives rubber/plastic rubbing strips, plastic fenders and other rubber parts on the boat a likenew appearance. Also suitable for refreshing coated railing wires or heavily weathered inflatable boats. Rubber Refresher is UV-stable and therefore particularly suitable for sunny areas. Extremely long service life and very good hydrophobicity with color deepening. No repolishing required. Salt water optimized. Areas of use (Soft) plastic, PVC and rubber on boats and yachts, e.g. plastic fenders, rubbing strakes made of rubber or plastic, coated railing seams Recommendations for use Remove dirt and grime from plastics, rubber scuff plates, plastic fenders or other rubber parts with an appropriate (pre-)cleaner and suitable accessories before care. Allow the surface to dry completely before further treatment. Spray Rubber Refresher onto a suitable applicator (e.g. Allround Microfiber Sponge) and apply to the surface to be treated. Work the product in thoroughly and allow to dry. Container Container Warnings Do not apply to surfaces where smoothness is undesirable, e.g. boat deck or running surfaces. Check suitability and compatibility before use; do not use on hot surfaces. Protect from frost and excessive heat. Do not use on gelcoat or boat paint. Notice This product information can advice you only without obligation. Liability on our part can not be derived.Please check whether the product is suitable for your application. We will be pleased to assist you. Powered by TCPDF (www.tcpdf.org)