Radon Barrier Radon is a radioactive gas generated when Uranium decays into Radium, that in turn breaks down to form Radon. By means of heat exchange, it penetrates buildings. Radon causes serious lung complaints. Waterproofing Membranes ELOTENE 3000X Self-Adhesive Bituminous Membrane with Cross-laminated HDPE Film DESCRIPTION Elotene 3000 X is a self-adhesive bituminous waterproofing membrane self-protected by a cross-laminated HDPE film. It consists in a very adhesive bituminous compound even at low temperatures. The high-density polyethylene film gives to the membrane characteristics of dimensional stability and ensures a uniform reaction to elongation stresses in a longitudinal and transversal direction. This membrane has been designed and developed for the specific waterproofing of vertical walls, foundations, basements, flat and ventilated roofs. Standard Length: 20 m *; Standard Thickness: 1.5 mm *; Standard Width: 1000 mm *. Other lengths and thicknesses are available on request. The rolls are packed individually in cardboard boxes and placed on pallets. • Waterproof, Self-adhesive and Self-sealing; • Tough and Extensible; • Radon and Methane Gas barrier; • Resistant to the contact of chemical agents; • Resistant to tearing and perforation; • Controlled thickness; • Compatible with steel and metals in general. USES • Waterproofing of foundations underground structures; • Waterproofing in atmospheres not compatible with the use of free fire flames (i.e. factories or warehouses where flammable chemical agents are produced or stored). SURFACE PREPARATION All surfaces on which Elotene Waterproofing membranes have to be installed must be dry, clean, smooth and free of impurities. If the surface is porous, apply a coat of Primer in a quantity of 75 - 150 g/sqm. The use of Primer is in any case advisable, and the manufacturers instructions must be followed. A wrong use of Primer can influence the membrane efficiency. APPLICATION Always start by laying the rolls from the highest point and work downwards, being careful not to create countergradient overlaps. The membrane must be overlapped at the edge by at least 5-8 cm and on the top by at least 15 cm. After installation, press the membrane well, being very careful about details such as corners, edges, connections and overlaps. * The product dimensions may vary within defined ranges because of the product characteristics and its manufacturing process. For further information please visit www.isoltemagroup.com

TECHNICAL DATA Static Load Resistance Tear Resistance Peel Resistance of Joints Shear Resistance of Joints Pass at 60 Kpa of water (24 hours) Pass at 6 bar of water (24 hours) Thickness Tensile Strength Elongation at Break Impact Resistance Peel Adhesion (on Concrete at 23°C) Probe Tack Vapour Transmission Rate Water Absorption Permeability to Radon Gas Permeability to Methane Gas SP Swedish Nat. Testing & Research Institute Application Temperature Service Temperature * For temperatures below 5 °C, it is recommended to use special and additional precautions to facilitate adhesion (for example...