Watertite Fillers Epoxy Filler PRODUCT DESCRIPTION Watertite is a quick drying epoxy filler suitable for use on GRP, Metals and rigid Wood constructions. The formulation does not shrink and is extremely water resistant, making it suitable for osmosis damage repairs. * Fill up to 20 mm without sagging * Use above and below the waterline * High strength and adhesion properties * Simple 1:1 mixing ratio for easy measurement of components * Very fast drying PRODUCT INFORMATION Colour YAV137 Light Blue Base product code is YAV334 & curing agent product code is YAA442. Specific Gravity Volume Solids Converter/Curing Agent Typical Shelf Life Unit Size DRYING/OVERCOATING INFORMATION Drying 10°C (50°F) Perfection Undercoat Yacht Primer Yacht Primer (Professional) The surface must be clean and dry. When treating osmosis, prime with Gelshield first. Otherwise prime as below. BARE GRP: Gelshield 200 or VC Tar 2 for osmosis protection, or Primocon. STEEL/IRON: Above water: Interprotect or Yacht Primer. Below water: Interprotect, or VC Tar 2, or Primocon. ALUMINIUM: Above water: Interprotect or Yacht Primer. Below water: Interprotect, or VC Tar 2, or Primocon. LEAD: VC Tar 2, or Interprotect or Primocon BARE WOOD: Above water: Yacht primer. Below water: Interprotect or Primocon. Remove any dust from the surface. Apply firmly in a spreading action. Fill to a level slightly above the surrounding area. When hardened, sand smooth with 80220 grade wet or dry paper. If left longer than 24 hours, two component epoxy fillers will need sanding with 80220 grade wet or dry paper to ensure a good physical key. Mixing: Mix the two components thoroughly to an even colour. Mix both components together thoroughly to correct mix ratio. Thinning: Do not thin. Cleaner: YTA061 International Epoxy Thinners #7. Ventilation and Humidity Control: Avoid cold, damp conditions which may cause a stickiness to form on the surface. This should be removed by water and a 3M Scotchbrite pad or sanding. Other: Large areas should be sanded with paper on a board twice the length of the repair area, this will allow for curvature of the hull. Small areas can be sanded using a sanding block. Sand as soon as possible after the sandable Please refer to your local representative or visit www.yachtpaint.com for further information. time as Watertite continues to harden with time. All trademarks mentioned in this publication are owned by, or licensed to, the AkzoNobel group of companies. © AkzoNobel 2018. Some Important Points Ref:10544 Watertite (2018) Do not use below 7°C. Do not apply more than 2.0 cm thickness at any one time. Product t

Remove any dust from the surface. Apply firmly in a spreading action. Fill to a level slightly above the surrounding area. When hardened, sand smooth with 80220 grade wet or dry paper. If left longer than 24 hours, two component epoxy fillers will need sanding with 80220 grade wet or dry paper to ensure a good physical key. Mixing: Mix the two components thoroughly to an even colour. Mix both components together thoroughly to correct mix ratio. Thinning: Do not thin. Cleaner: YTA061 International Epoxy Thinners #7. Ventilation and Humidity Control: Avoid cold, damp conditions which may cause...