Original Varnishes Full Gloss Yacht VarnishSuitable for power and sail boats PRODUCT DESCRIPTION A traditional yacht varnish with UV resistance. Features include excellent flexibility, ease of application, good gloss retention, and nonblooming qualities. A high clarity finish especially suited to lighter colour timbers. PRODUCT INFORMATION Colour High Gloss Specific Gravity Volume Solids Typical Shelf Life Unit Size DRYING/OVERCOATING INFORMATION Drying 5°C (41°F) PREVIOUSLY VARNISHED WOOD In Good Condition Clean the surface with Super Cleaner. Sand smooth with 280320 grade paper. Remove sanding dust with thinners. In Poor Condition Remove all previous coatings. BARE WOOD Ensure that the surface is thoroughly degreased. Sand smooth with 80180 grade paper and then 280 grade paper. Remove sanding dust by brushing, dusting and wiping. If wiping with solvent then allow to dry completely before applying the first coat. Priming bare wood: Thin the first coat by 1015% with Thinner No.1. Apply a minimum of 3 unthinned coats, more if using a roller. For best results sand smooth between coats with 320400 grade wet or dry paper. Avoid using direct from the can. Pour the amount you expect to use in a separate container. Mixing Stir well before use. Thinner Brush YTA800 Thinner No. 1. Spray Thinner 910 or Thinner 920 Cleaner Thinner No.1 Roller If applying by roller, lay off with a brush or pad otherwise air bubbles may become trapped in the film. Airless Spray (Professional spray application only) Pressure: 176210 bar. Tip Size: 13651580. Conventional Spray (Professional spray application only) Pressure: 23 bar. Tip Size: 1.11.4 mm. Thin 2025% with Thinner 910 or Thinner 920. Airmix spray (Professional spray application only) Pressure: 2 bar. Tip Size: 06113. For best results sand lightly between coats with 320400 grade paper. Avoid using direct from the can. Pour the amount you expect to use in a separate container. Some Important Points Use above the waterline only. Do not use below 5°C. Avoid painting in direct sunlight. Product temperature should be minimum 15°C and maximum 35°C. Ambient temperature should be minimum 5°C/41°F and maximum 35°C/95°F. Substrate temperature should be minimum 5°C/41°F and maximum 35°C/95°F. Suitable for use on all types of wood as long as correct surface preparation has been carried out. (Theoretical) 13.0 m²/L per coat (Practical) 11.7 m²/L per coat Application Methods Brush, Roller, Conventional Spray, Airless Spray, Airmix (Professional spray application only). Please refer to your local representative or visit www.yachtpaint.com for further information. TRANSPORTATION, STORAGE AND SAFETY INFORMATION All trademarks mentioned in this publication are owned by, or licensed to, the AkzoNobel group of companies. © AkzoNobel 2019.

temperature should be minimum 5°C/41°F and maximum 35°C/95°F. Compatibility/Substrates Suitable for use on all types of wood as long as correct surface preparation has been carried out. (Theoretical) 13.0 m²/L per coat (Practical) 11.7 m²/L per coat Recommended WFT per coat 77 microns wet by brush Full Gloss Yacht VarnishSuitable for power and sail Application Methods Brush, Roller, Conventional Spray, Airless Spray, Airmix (Professional spray application only). TRANSPORTATION, STORAGE AND SAFETY INFORMATION Storage GENERAL INFORMATION: Exposure to air and extremes of temperature should be avoided....