Gelshield 200 Osmosis Epoxy Primer for Osmosis Protection PRODUCT DESCRIPTION Quick drying, easy to apply, epoxy primer for protection of GRP against osmosis. * Provides protection against osmosis in five coats (250 µm) * Useable down to 5°C * Fast drying allows multiple coat application in a single day PRODUCT INFORMATION Colour Specific Gravity Volume Solids Converter/Curing Agent Typical Shelf Life Unit Size DRYING/OVERCOATING INFORMATION Drying 5°C (41°F) Note: For all other International antifoulings such as Cruiser Uno EU, Boatguard EU, Ultra EU, Cruiser Polishing Antifouling, Cruiser Premium Plus, Interspeed Extra, Micron Superior, Micron Extra EU, Micron LZ, Micron 77, Navigator, Ultra 300, Boatguard 100, Cruiser 200/250, Trilux 200 and Trilux Hard Antifouling, UniPro 250 use the Micron 350 overcoating times. If maximum overcoating time is exceeded, sand with 180220 grade wet or dry paper. BARE GRP Wash down with Super Cleaner, rinse with fresh water and allow to dry. Sand with 180 grade (grit) paper. PREVIOUSLY ANTIFOULED SURFACE Remove using Interstrip. Wash down with Super Cleaner, rinse with fresh water and allow to dry. Sand with 180 grade (grit) paper. EXPOSED LAMINATE Patch prime using Gelshield Plus. Remove any dust from the surface. Apply required number of coats, detailed in the specification sheets (minimum 250 microns DFT). For ease, alternate the grey and green colours starting and ending with grey. BILGES: Apply 2 coats only provided there is a gelcoat on the inside of the hull. If no gelcoat, use Gelshield Plus. Mixing Stir or shake individual components thoroughly. Add Curing Agent to the Base, stir and leave for 10 minutes to allow bubbles to disperse. Thinner YTA061 Thinners No.7 Other Can be used down to 5°C but for maximum performance, temperature should be above 10°C. Some Important Points New hulls must be postcured for a min. period of 4 weeks before applying Gelshield 200 . Do not apply direct to the exposed laminate. Do not use below 5°C. Ambient temperature should be minimum 5°C/41°F and maximum 35°C/95°F. Product temperature should be minimum 10°C and maximum 35°C. Substrate temperature should be minimum 5°C/41°F and maximum 35°C/95°F. GRP Gelcoats & cured laminate . It should not be used over any one pack products. (Theoretical) 9.1 m²/L per coat by brush (Practical) 8.1 m²/L per coat by brush Application Methods Brush, Roller Please refer to your local representative or visit www.yachtpaint.com for further information. All trademarks m

Other Can be used down to 5°C but for maximum performance, temperature should be above 10°C. Some Important Points New hulls must be postcured for a min. period of 4 weeks before applying Gelshield 200 . Do not apply direct to the exposed laminate. Do not use below 5°C. Ambient temperature should be minimum 5°C/41°F and maximum 35°C/95°F. Product temperature should be minimum 10°C and maximum 35°C. Substrate temperature should be minimum 5°C/41°F and maximum 35°C/95°F. GRP Gelcoats & cured laminate . It should not be used over any one pack products. Compatibility/Substrates Number of Coatsfor...