Fibreglass Surface Prep PRODUCT DESCRIPTION Fibreglass Surface Prep is a mould release agent remover, which precludes the need for sanding bare GRP when used with International's No Sand Primer. Fibreglass Surface Prep thoroughly cleans the gelcoat and provides a key for Fibreglass No Sand Primer to be applied. Fibreglass Surface Prep can also be used to prepare aged and weathered alkyds prior to application of subsequent coats by softening the surface slightly. Surface Prep Fibreglass Surface Prep thoroughly cleans and degreases the gelcoat, removing all waxes Fibreglass Surface Prep abrades, cleans and softens old alkyds promoting adhesion of subsequent coats. Easy application with a cloth or sponge creates a good key on the gelcoat surface, while avoiding dust and noise created through abrasion with sand paper. The tinted colour of Fibreglass Surface Prep ensures it is easy to see where the product has been applied to white gelcoat, and makes it difficult to miss areas unintentionally. PRODUCT DATA AVAILABLE SHADES PACK SIZE Typical Shelf Life Refer to Fibreglass Surface Prep product data sheet for more information Always read the Health & Safety precautions on the label prior to use Above and below the waterline Cloth / Sponge

SURFACE PREPARATIONS AND SYSTEMS Apply Fibreglass Surface Prep to a damp cloth or sponge, then wipe the whole surface to be cleaned using moderate pressure. Wipe off with a clean, wet, cloth ensuring no traces of Fibreglass Surface Prep remain. As soon as the surface is dry, it is ready to paint. BARE GRP: If the overcoating time exceeds 4 hours, ensure that the surface is clean and dry prior to ALKYDS: If the overcoating time exceeds 4 hours, re-apply Fibreglass Surface Prep prior to subsequent CAUTION: Protect from frost. Fibreglass Surface Prep will not remove serious blemishes. OVERCOATING...