Vinyl Anticorrosive PRODUCT DESCRIPTION A one pack, tar free vinyl anticorrosive which can be used at temperatures down to 23°F. INTENDED USES PRODUCT INFORMATION As an anticorrosive for both above and below the waterline and also as a sealer coat over Tributyltin (TBT) Suitable for use with controlled cathodic protection. For use at Newbuilding, Maintenance & Repair or On Board Maintenance. Part B (Curing Agent) Volume Solids Typical Film Thickness Theoretical Coverage Flash Point Induction Period 214 ft2/US gal at 3 mils dft, allow appropriate loss factors Airless Spray, Brush, Roller Drying Information Overcoating Data - see limitations Substrate Temperature Note For other antifoulings, consult International Paint. REGULATORY DATA 529 g/lt (4.41 lb/US gal) as supplied (EPA Method 24) 498 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings

Vinyl Anticorrosive SURFACE PREPARATIONS When used as part of an approved scheme, this product has the following certification: When tested in accordance with ASTM D5108-96 (modified) Intertuf 203 forms a barrier to TBT leaching from an underlying TBTantifouling. Long term testing is ongoing. Consult your International Paint representative for details. Consult your International Paint representative for the system best suited for the surfaces to be protected. Use in accordance with the standard Worldwide Marine Specifications. All surfaces to be coated should be clean, dry and free from contamination....

Vinyl Anticorrosive Airless Spray Conventional Spray This material is a one pack coating and should always be mixed thoroughly with a power agitator before Not recommended. Use International GTA007 only in exceptional circumstances. DO NOT thin more than allowed by local environmental legislation. Total output fluid pressure at spray tip not less than 3000 psi (211 kg/cm2) Application by conventional spray is not recommended. Application by brush is recommended for small areas only. Multiple coats may be required to achieve specified film thickness. Application by roller is recommended for small...

Vinyl Anticorrosive Optimum performance is achieved when Intertuf 203 is applied over blasted steel. Intertuf 203, JVA202 aluminium must be specified as the first coat in an anticorrosive system. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative for specific recommendations. Apply in good weather. Temperature of the surface to be coated must be at least 5°F above the dew point. For optimum application properties bring the material to 70°F-81°F,...