Catalogs >
International Marine >
Intershield 852

Intershield 852
4Pages

Catalog excerpts

Intershield 852 Epoxy Non-Skid PRODUCT DESCRIPTION A high build, spray applied, two pack epoxy medium texture non-skid finish. Intershield 852 is hard wearing with good chemical resistance. INTENDED USES As a non-skid flight deck coating, complying with DEF STAN 80-134 Type 1- Medium Texture. Intershield 852 can also be used on any other deck or walkway subject to heavy wear. PRODUCT INFORMATION ADA112-Extra Dk Sea Grey, ADA113-Dk Admiralty Grey Part B (Curing Agent) Volume Solids 4.66 volume(s) Part A to 1 volume(s) Part B Typical Film Thickness Theoretical Coverage 30 ft²/US gal at 40 mils dft, allow appropriate loss factors Conventional Spray, Roller Flash Point Part A 73°F; Part B 214°F; Mixed 106°F Induction Period Drying Information Overcoating Data - see limitations Substrate Temperature REGULATORY DATA 219 g/lt (1.83 lb/US gal) as supplied (EPA Method 24) 137 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. DEF STAN Marine Coatings Page 1 of 4 Issue Date:11/12/2018 Ref:48 Complies with DEF STAN 80-134 Type 1- Medi

Open the catalog to page 1

Intershield 852 Epoxy Non-Skid SYSTEMS AND COMPATIBILITY Consult your International Paint representative for the system best suited for the surfaces to be protected. SURFACE PREPARATIONS Use in accordance with the standard Worldwide Marine Specifications. All surfaces to be coated should be clean, dry and free from contamination. High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning. NEWBUILDING/MAJOR REFURBISHMENT Intershield 852 should always be applied...

Open the catalog to page 2

Intershield 852 Epoxy Non-Skid APPLICATION Mixing Material is supplied in two containers as a unit. Always mix a complete unit in the portions supplied. Once the unit has been mixed it must be used within the working pot life specified. (1) Agitate Base (Part A) with power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. Not Recommended. Use International GTA220 only in exceptional circumstances (max 5% by volume). DO NOT thin more than allowed by local environmental legislation. Airless Spray Conventional Spray...

Open the catalog to page 3

Intershield 852 Epoxy Non-Skid LIMITATIONS This product will not cure adequately below 41°F. For maximum performance ambient curing temperatures should be above 50°F. In common with all epoxy based coatings Intershield 852 will exhibit chalking of the film on UV exposure. Rate of chalking will depend upon climatic conditions. Except in hot countries, chalking will be limited to a thin surface layer. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint...

Open the catalog to page 4