Intershield 851 Epoxy Non-Skid PRODUCT DESCRIPTION A high build, spray applied, two pack epoxy coarse texture non-skid finish. Hard wearing with good chemical resistance. INTENDED USES As a non-skid flight deck coating complying with DEF STAN 80-134 Type 2 - Coarse Texture. Can also be used on any other deck or walkway subject to heavy wear. PRODUCT INFORMATION Part B (Curing Agent) Volume Solids 5.42 volume(s) Part A to 1 volume(s) Part B Typical Film Thickness Theoretical Coverage 31 ft²/US gal at 40 mils dft, allow appropriate loss factors Conventional Spray, Roller Flash Point Part A 73°F; Part B 214°F; Mixed 106°F Induction Period Drying Information Overcoating Data - see limitations Substrate Temperature REGULATORY DATA 111 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. DEF STAN Marine Coatings Page 1 of 4 Issue Date:2/4/2015 Ref:685 Complies with DEF STAN 80-134 Type 2 - Coars

Intershield 851 Epoxy Non-Skid SYSTEMS AND COMPATIBILITY Consult your International Paint representative for the system best suited for the surfaces to be protected. SURFACE PREPARATIONS Use in accordance with the relevant Naval Engineering Standards and Drawings. All surfaces to be coated should be clean, dry and free from contamination. High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning. NEWBUILDING/MAJOR REFURBISHMENT Intershield 851 should always be applied...

Intershield 851 Epoxy Non-Skid APPLICATION Mixing Material is supplied in two containers as a unit. Always mix a complete unit in the portions supplied. Once the unit has been mixed it must be used within the working pot life specified. (1) Agitate Base (Part A) with power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. Not recommended. Use International GTA220 only in exceptional circumstances (max 5% by volume). DO NOT thin more than allowed by local environmental legislation. Airless Spray Conventional Spray Recommended....

Intershield 851 Epoxy Non-Skid LIMITATIONS This product will not cure adequately below 41°F. For maximum performance ambient curing temperatures should be above 50°F. In common with all epoxy based coatings Intershield 851 will exhibit chalking of the film on UV exposure. Rate of chalking will depend upon climatic conditions. Except in hot countries, chalking will be limited to a thin surface layer. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative...