Catalogs >
International Marine >
Intershield 803Plus

Intershield 803Plus
4Pages

Catalog excerpts

Intershield 803Plus Abrasion Resistant Epoxy PRODUCT DESCRIPTION An ultra high performance pure epoxy cargo hold coating with excellent mechanical properties, which will provide superior impact and abrasion resistance. INTENDED USES As an ultra high performance two pack abrasion resistant pure epoxy coating, providing excellent protection from impact shooting damage caused by high speed loading mechanisms. Will limit mechanical damage and subsequent corrosion from all other forms of abrasion. For use as a cargo hold coating at Maintenance and Repair only. PRODUCT INFORMATION Part B (Curing Agent) Volume Solids 4.5 volume(s) Part A to 1 volume(s) Part B Typical Film Thickness Theoretical Coverage 241 ft²/US gal at 5 mils dft, allow appropriate loss factors Airless Spray Flash Point Part A 86°F; Part B 108°F; Mixed 93°F Induction Period Drying Information Overcoating Data - see limitations REGULATORY DATA Substrate Temperature 248 g/lt (2.07 lb/US gal) as supplied (EPA Method 24) 166 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) 148 g/lt Chinese National Standard GB23985 Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings Page 1 of 4 Issue Date:11/13/201

Open the catalog to page 1

Intershield 803Plus Abrasion Resistant Epoxy CERTIFICATION When used as part of an approved scheme, this material has the following certification: • Food Contact - Carriage of Grain (NOHA) • Food Contact - FDA Compliant: Dry Foodstuffs Consult your International Paint representative for details. SURFACE PREPARATIONS Use in accordance with the standard Worldwide Marine Specifications. All surfaces to be coated should be clean, dry and free from contamination. High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other...

Open the catalog to page 2

Intershield 803Plus Abrasion Resistant Epoxy APPLICATION Mixing Material is supplied in 2 containers as a unit. Always mix a complete unit in the proportions supplied. (1) Agitate Part A with a power agitator, (2) Combine entire contents of Part A and B and mix thoroughly with a power agitator. Not recommended. Use International GTA220 only in exceptional circumstances. DO NOT thin more than allowed by local environmental legislation. Note 1: For use as a holding primer thin 5% by volume with GTA220 Note 2: For use as a holding primer below 10°C, thin 10% by volume with GTA220 Airless Spray...

Open the catalog to page 3

Intershield 803Plus Abrasion Resistant Epoxy LIMITATIONS UNIT SIZE The coating will exhibit surface discoloration if immersed in seawater after application and curing at temperatures <50°F. This does not effect the performance characteristics of the product. Intershield 803Plus will cure down to 23°F but will require a period of cure above 41°F to achieve full mechanical properties. Consult International Paint. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International...

Open the catalog to page 4