Intershield 803Abrasion Resistant Epoxy PRODUCT DESCRIPTION A two pack, abrasion resistant pure epoxy coating with excellent mechanical properties. INTENDED USES As a high performance two pack abrasion resistant pure epoxy coating to limit mechanical damage and subsequent corrosion. Suitable for cargo holds and also exterior hulls of ice-going vessels. Suitable for use with controlled cathodic protection. For use at Maintenance & Repair. PRODUCT INFORMATION Colour Finish/Sheen Part B (Curing Agent) Volume Solids Mix Ratio Typical Film Thickness Theoretical Coverage Method of Application Flash Point (Typical) Induction Period EGA807-Grey, EGA808-Red Matt EGA809 75% ±2% (ISO 3233:1998) 4 volume(s) Part A to 1 volume(s) Part B 125 microns dry (167 microns wet) 6 m2/litre at 125 microns dft, allow appropriate loss factors Airless Spray Part A 37°C; Part B 49°C; Mixed 39°C Not required Overcoating Data - see limitations 5°C Overcoated By Min Max Note At temperatures <15°C, a coat of Intergard 263 is required prior to the application of Interthane 990. At temperatures between 15°C and 40°C, Interthane 990 can be applied direct, in accordance with the overcoating intervals stated. For application of Interthane 990 at temperatures in excess of 40°C consult your International Paint representative. REGULATORY DATA VOC 222 g/lt as supplied (EPA Method 24) 129 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) 212 g/lt Chinese National Standard GB23985 Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances. Marine Coatings Page 1 of 4 Issue Date:19/05/2016 Ref:901

Abrasion Resistant Epoxy CERTIFICATION When used as part of an approved scheme, this material has the following certification:

Intershield 803 Abrasion Resistant Epoxy LIMITATIONS UNIT SIZE The coating will exhibit surface discolouration if immersed in seawater after application and curing at temperatures <10°C. This does not effect the performance characteristics of the product. Intershield 803 will cure down to -5°C but will require a period of cure above 5°C to achieve full mechanical properties. Consult International Paint. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative...