Interline 994LT Epoxy Novolac Phenolic Tank Coating PRODUCT DESCRIPTION A two pack, novolac phenolic epoxy cargo tank coating for application down to 5°C. INTENDED USES Suitable for the carriage of an extensive range of aggressive cargoes including solvents and chemicals, clean and dirty petroleum products, vegetable and animal oils. For use at Newbuilding or Maintenance & Repair. PRODUCT INFORMATION Part B (Curing Agent) Volume Solids 5.22 volume(s) Part A to 1 volume(s) Part B Typical Film Thickness Theoretical Coverage 7.00 m²/litre at 100 microns dft, allow appropriate loss factors Airless Spray, Brush, Roller Flash Point (Typical) Part A 25°C; Part B 27°C; Mixed 26°C Induction Period Drying Information Pot life may be extended for brush/roller application, consult International Paint for guidance. Overcoating Data - see limitations Substrate Temperature REGULATORY DATA 280 g/lt as supplied (EPA Method 24) 209 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances. Marine Coatings Page 1 of 4 Issue Date:12/10/202

Interline 994LT Epoxy Novolac Phenolic Tank Coating CERTIFICATION When used as part of an approved scheme, this product has the following certification: • Food Contact - FDA Compliant in accordance with section 175.300 of the Code of Federal Regulations • Food Contact - Compliant with EU Framework Directive 1935/2004 Consult your International Paint representative for details. When using in cargo or grey water tanks, consult the Interline 994LT Cargo Tank or Grey Water Tanks Application Guidelines. Consult your International Paint representative for the system best suited for the surfaces to...

Interline 994LT Epoxy Novolac Phenolic Tank Coating APPLICATION Mixing Material is supplied in 2 containers as a unit. Always mix a complete unit in the proportions supplied. (1) Agitate Base (Part A) with a power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. Not recommended. Use International GTA007 only in exceptional circumstances. DO NOT thin more than allowed by local environmental legislation. Airless Spray Recommended Tip Range 0.38-0.58 mm (15-23 thou) Total output fluid pressure at spray tip not less than 176...

Interline 994LT Epoxy Novolac Phenolic Tank Coating LIMITATIONS Film Thickness The minimum dft for the system is 240 microns. The maximum dft for the system is 450 microns. In way of areas of tanks that are difficult to paint due to their configuration , e.g heavily stiffened tanks, and where a degree of overthickness is unavoidable, a maximum of 600 microns dft is acceptable. This product will not cure adequately below 5°C. At no time during the application, and up to the first 48 hours after application of the final coat must the steel temperature fall below 5°C and the relative humidity exceed...