Interline 9001Bimodal Polymer PRODUCT DESCRIPTION A two pack, low absorption, easy clean, high performance chemical tank coating. INTENDED USES Suitable for the carriage of an extensive range of aggressive cargoes including solvents and chemicals, clean and dirty petroleum products, vegetable oils and animal oils. For use at Newbuilding or Maintenance & Repair. PRODUCT INFORMATION ColourFinish/Sheen Part B (Curing Agent) Volume Solids Mix Ratio Typical Film Thickness Theoretical Coverage Method of Application Flash Point (Typical) Induction Period 7.52 volume(s) Part A to 1 volume(s) Part B 150 microns dry (188 microns wet) 5.33 m2/litre at 150 microns dft, allow appropriate loss factors Airless Spray, Brush, Roller Part A 34°C; Part B 100°C; Mixed 46°C Overcoating Data - see limitations Substrate Temperature REGULATORY DATA VOC 177 g/lt as supplied (EPA Method 24) 93 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) 115 g/lt Chinese National Standard GB23985 Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances.

Interline 9001 Bimodal Polymer CERTIFICATION When used as part of an approved scheme, this material has the following certification: • Food Contact - FDA Compliant in accordance with section 175.300 of the Code of Federal Regulations Consult your International Paint representative for details. Consult your International Paint representative for the system best suited for the surfaces to be protected. SURFACE PREPARATIONS Use in accordance with the standard Worldwide Marine Specifications. All surfaces to be coated should be clean, dry and free from contamination. High pressure fresh water wash...

Interline 9001 Bimodal Polymer APPLICATION Mixing Material is supplied in 2 containers as a unit. Always mix a complete unit in the proportions supplied. Once the unit has been mixed it must be used within the working pot life specified. (1) Agitate Base (Part A) with a power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. Mixed unit MUST BE >20°C during mixing and application. Airless Spray Recommended Tip Range 0.38-0.58 mm (15-23 thou) Total output fluid pressure at spray tip not less than 176 kg/cm² (2500 p.s.i.) Conventional...

Interline 9001 Bimodal Polymer LIMITATIONS Film Thickness The minimum dft for the system is 240 microns. The maximum dft for the system is 450 microns. In way of areas of tanks that are difficult to paint due to their configuration , e.g heavily stiffened tanks, and where a degree of overthickness is unavoidable, a maximum of 600 microns dft is acceptable. This product will not cure adequately below 15°C. At no time during the application, and up to the first 48 hours after application of the final coat must the steel temperature fall below 15°C and the relative humidity exceed 50%. International...