INTENDED USES Alkyd Finish A one pack alkyd gloss finish. For use as an easily maintained cosmetic finish coat on areas above the waterline. For use at Newbuilding, Maintenance & Repair or On Board Maintenance. Part B (Curing Agent) Volume Solids CLBOOO-White, CLD260-lntl. Orange, CLK724-Storm Grey, CLL274-Red, CLL549-Signal Green, CLY999-Black ; and a wide range of colors. High Gloss Typical Film Thickness Theoretical Coverage Flash Point 481 ft2/US gal at 1.6 mils dft, allow appropriate loss factors Airless Spray, Brush, Conventional Spray, Roller Single Pack 104°F (Product produced and supplied in North America has a flashpoint of 106°F due to locally sourced solvents. There is no detrimental effect on product performance.) Drying Information Overcoating Data - see limitations Substrate Temperature REGULATORY DATA 420 g/lt (3.50 lb/US gal) as supplied (EPA Method 24) 364 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings

Alkyd Finish When used as part of an approved scheme, this material has the following certification: Fire Resistance - Surface Spread of Flame (WFR) - (IMO Resolution A653 (16)) Fire Resistance - MSC61(67) Smoke & Toxicity (WFR) Fire Resistance - Marine Equipment Directive compliant Food Contact - Carriage of Grain (NOHA) Meets Petrobras Standard N-2492 - Alkyd Finish Gloss Fire Resistance - US Coast Guard Type Approval of Interior Finish Consult your International Paint representative for details. Interlac 665 should only be applied over recommended anticorrosive primers. The primer to be used...

Alkyd Finish Airless Spray Conventional Spray This material is a one pack coating and should always be mixed thoroughly with a power agitator before Not recommended. Use International GTA004 only in exceptional circumstances (max 5% by volume). DO NOT thin more than allowed by local environmental legislation. Total output fluid pressure at spray tip not less than 2010 psi (141 kg/cm2) Use suitable proprietary equipment. Thinning may be required. Thoroughly flush all equipment with International GTA004. All unused material should be stored in tightly closed containers. Partially filled containers...

Alkyd Finish Interlac 665 is not suitable for use on immersed areas. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative for specific recommendations. Apply in good weather. Temperature of the surface to be coated must be at least 5°F above the dew point. For optimum application properties bring the material to 70°F-81°F, unless specifically instructed otherwise, prior to mixing and application. Unmixed material (in closed containers) should be maintained...