Intergard 7020Abrasion Resistant Aluminium Pure Epoxy PRODUCT DESCRIPTION A two pack, abrasion resistant aluminium pure epoxy with good anticorrosive performance. INTENDED USES As an abrasion resistant pure epoxy to limit mechanical damage and subsequent corrosion in cargo holds. For use at Newbuilding and Maintenance & Repair. PRODUCT INFORMATION ColourFinish/Sheen Part B (Curing Agent) Volume Solids Mix Ratio Typical Film Thickness Theoretical Coverage Method of Application Flash Point (Typical) Induction Period 3 volume(s) Part A to 1 volume(s) Part B 125 microns dry (169 microns wet) 5.92 m2/litre at 125 microns dft, allow appropriate loss factors Airless Spray, Brush, Roller Part A 36°C; Part B 32°C; Mixed 34°C Overcoating Data - see limitations 20 hrs 3 mths 16 hrs 3 mths 12 hrs 3 mths 6 hrs 3 mths REGULATORY DATA VOC 239 g/lt as supplied (EPA Method 24) 177 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Directive 1999/13/EC) 224 g/lt Chinese National Standard GB23985 Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances. Marine Coatings Page 1 of 4

Intergard 7020 Abrasion Resistant Aluminium Pure Epoxy CERTIFICATION When used as part of an approved scheme, this product has the following certification: • Food Contact - Carriage of Grain (NOHA) • Food Contact - FDA Compliant: Dry Foodstuffs Consult your International Paint representative for details. Consult your International Paint representative for the system best suited for the surfaces to be protected. SURFACE PREPARATIONS Use in accordance with the standard Worldwide Marine Specifications. All surfaces to be coated should be clean, dry and free from contamination. High pressure fresh...

Intergard 7020 Abrasion Resistant Aluminium Pure Epoxy APPLICATION Mixing Material is supplied in 2 containers as a unit. Always mix a complete unit in the proportions supplied. Once the unit has been mixed it must be used within the working pot life specified. (1) Agitate Base (Part A) with a power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. International GTA220. Thinning is not normally required. Consult the local representative for advice during application in extreme conditions. Do not thin more than allowed by...

Intergard 7020 Abrasion Resistant Aluminium Pure Epoxy LIMITATIONS UNIT SIZE When spraying large areas, application of a brush coat is recommended over pitted or rough surfaces to ensure full penetration. Stripe coating of complex structures is recommended. Optimum performance is achieved when Intergard 7020 is applied over blasted steel. Intergard 7020 will cure down to -5°C but will require a period of cure above 5°C to achieve full mechanical properties. Consult International Paint. The coating will exhibit surface discolouration if immersed in seawater after application and curing at temperatures...