PRODUCT DESCRIPTION A two pack epoxy coating, containing micaceous iron oxide, which can be overcoated after extended periods. INTENDED USES PRODUCT INFORMATION As a general purpose primer for above water areas. Part B (Curing Agent) Volume Solids Typical Film Thickness Theoretical Coverage Flash Point Induction Period EPA001-MIO Dark Grey, EPA007-MIO Light Grey 5.67 volume(s) Part A to 1 volume(s) Part B 209 ft2/US gal at 5 mils dft, allow appropriate loss factors Airless Spray, Roller, Brush Part A 73°F; Part B 73°F; Mixed 77°F 30 minutes at temperatures below 77°F Drying Information Overcoating Data - see limitations Substrate Temperature Note For overcoating Intergard 400 with Intergard 410, Intergard 415 and Intergard 740 see Special Note in Surface Preparation section. REGULATORY DATA 307 g/lt (2.56 lb/US gal) as supplied (EPA Method 24) 221 g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council Note: VOC values are typical and are provided for guidance purposes only. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Marine Coatings

SURFACE PREPARATIONS When used as part of an approved scheme, this material has the following certification: Food Contact - Carriage of Grain (NOHA) Food Contact - FDA Compliant: Dry Foodstuffs Fire Resistance - Surface Spread of Flame (WFR) - (IMO Resolution A653 (16)) Fire Resistance - MSC61(67) Smoke & Toxicity (WFR) Fire retardant: Naval Engineering Standard 713 Fire Resistance - Marine Equipment Directive compliant Corrosion Control - China Classification Society Consult your International Paint representative for details. Consult your International Paint representative for the system best...

Airless Spray Conventional Spray Work Stoppages and Cleanup Material is supplied in 2 containers as a unit. Always mix a complete unit in the proportions supplied. (1) Agitate Base (Part A) with a power agitator. (2) Combine entire contents of Curing Agent (Part B) with Base (Part A) and mix thoroughly with power agitator. Not recommended. Use International GTA220 only in exceptional circumstances. DO NOT thin more than allowed by local environmental legislation. Total output fluid pressure at spray tip not less than 2500 psi (176 kg/cm2) Application by conventional spray is not recommended....

This product will not cure adequately below 32°F. For maximum performance ambient curing temperature should be Optimum performance is achieved when Intergard 400 is applied over blasted steel. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative for specific recommendations. Apply in good weather. Temperature of the surface to be coated must be at least 5°F above the dew point. For optimum application properties bring the material to 70°F-81°F, unless...