POLYURETHANE + ACRYLIC ENAMEL

Product catalog summary

Product Overview: The Polyurethane + Acrylic Enamel is a two-component gloss enamel suitable for both indoor and outdoor use. It is known for its extraordinary whiteness, non-yellowing properties, and superior resistance to various environmental factors, making it ideal for marine environments.

Fields of Application: This product is designed for decoration and protection of surfaces, particularly in aggressive environments like marine settings. It is recommended for direct application on polyester surfaces.

Technical Specifications:

Product Type: Acrylic polyol and aliphatic isocyanate
Finish: Gloss
Density: 1.00 - 1.30 Kg/l
Coverage: 14 - 18 m2/l
Drying Time: 4 - 6 hours at 23ºC, 60% RH
Recoat Time: 12 - 24 hours
Mixing Ratio: Base 4 parts, Hardener 1 part
Application Methods: Brush, Roller, Spray-gun
Application Temperature: +10ºC to +30ºC
Flash Point: Base 35 ºC, Hardener 38 ºC
Volume Solids: 52 - 54%
Pack Sizes: 2.5 l (white only) and 750 ml

Application Instructions:

Ensure surfaces are clean, dry, and prepared.
For bare surfaces, apply appropriate primers before the enamel.
For maintenance, repair and sand surfaces before applying the enamel.

Precautions: Store in tightly closed containers away from heat and below 0ºC. Follow local waste management regulations and avoid environmental contamination.

Additional Information: The product complies with UNE 48274:2003 Standard. The shelf life is 36 months in unopened packaging. For any doubts, consult the technical service.

Catalog excerpts

POLYURETHANE + ACRYLIC ENAMEL Indoors - Outdoors. Gloss Description Two-component gloss enamel. The white has an extraordinary whiteness and does not yellow. Maximum toughness, gloss retention and elasticity. Superior resistance to rubbing, chemical agents, grease and petroleum. In any kind of aggressive environments, especially by the sea. Great washability. Fields of Application Outdoor and indoor use. For the decoration and protection of surfaces in marine environments or under strain. Long life. Long colour and gloss retention. Especially recommended for direct application on polyester. Technical Data Product Type Acrylic polyol and aliphatic isocyanate White and colour range 12 - 24 hours (After 24 h., lightly sand before applying the next coat.) Mixing Rate Base: 4 parts. Hardener: 1 part. Brush, Roller and Spray-gun (Application by brush is only recommended for small or narrow surfaces) Equipment Cleaning TITAN YATE Thinner Pack sizes 2.5 l (Only available in white) and 750 ml. Variations in temperature, humidity, thickness, tinting or surface type, etc. may lead to changes in drying, in coverage or in other properties. Certificates It complies with UNE 48274:2003 Standard Directions for use GENERAL REMARKS

Open the catalog to page 1

Thoroughly stir the contents in the pack. The surfaces have to be clean, dry and suitably prepared. Remove any rest of dirt, grease, poorly adhered rust or old coats by using thinner or paint-stripper, depending on needs. BARE SURFACES: Wood: Sand the wood following the wood grain. Clean the surface, remove resin or resin secretion and smooth too sharp edges. Apply TITAN YATE Epoxy Primer. Iron and steel: Wash, remove rust and apply TITAN YATE Epoxy Primer and M150 Thick Coat Epoxy Primer. Tile and non ferrous metals: Degrease and apply TITAN YATE Epoxy Primer, depending on needs. In all cases...

Open the catalog to page 2